Microstructure changes responsible for the degradation of the 10CrMo9-10 and 13CrMo4-5 steels during long-term operation
Authors:
Open Access
- 23 December 2019
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (1) , 016515
Abstract
The paper presents results of microstructure and mechanical testing examinations performed using optical and transmission electron microscopy, tensile tests and Charpy tests on 10CrMo9-10 and 13CrMo4-5 steels, before and after they were long-term operated at elevated temperatures in a steam heater. In the 10CrMo9-10 steel, the optical microscopy detected a degradation of original bainite that was accompanied by the formation of ferrite, precipitates and micropores. The transmission electron microscopy revealed that the precipitates are M23C6 and M7C3 type carbides, which are located mainly at the boundaries of former austenite grains, and M3C type carbides, which appear inside the grains. The 13CrMo4-5 steel contained a relatively high amount of ferrite in the ferritic-bainitic/perlitic microstructure already in the originally state. The degradation of the microstructure was less serious than for the 10CrMo9-10 steel. The thermal treatment of the 13CrMo4-5 steel led mainly to the precipitation of carbides. The M23C6 and M7C3 type carbides form in perlitic-bainitic areas, while M3C and M6C type carbides precipitate in ferrite. The higher density of the grain boundary precipitates in the long-term operated 10CrMo9-10 steel facilitated the formation of creep-induced micropores and contributed to the hardness reduction.Keywords
This publication has 21 references indexed in Scilit:
- Analysis of Crystallite Size Changes in an Oxide Layer Formed on Steel Used in the Power IndustryActa Physica Polonica A, 2016
- The Defects of Oxide Layers Formed on 10CrMo9-10 Steel Operated for 200,000 Hours at an Elevated TemperatureArchives of Metallurgy and Materials, 2016
- Effect of cw-CO2 laser surface treatment on structure and properties of AZ91 magnesium alloyOptics and Lasers in Engineering, 2016
- Evolution of phases in P91 steel in various heat treatment conditions and their effect on microstructure stability and mechanical propertiesMaterials Science and Engineering: A, 2016
- Dominating High Temperature Corrosion Mechanisms in Low Alloy Steels in Wood Chips Fired BoilersEnergy & Fuels, 2016
- Carbide evolution and service life of simulated post weld heat treated 2.25Cr–1Mo steelMaterials Science and Engineering: A, 2015
- Investigation on the precipitation behavior of M3C phase in T91 ferritic steelsNuclear Engineering and Design, 2011
- Rietveld quantitative analysis of carbides precipitation in normalized-tempered 2.25Cr-1Mo-0.25V steelJournal of Wuhan University of Technology-Mater. Sci. Ed., 2009
- Experience on in-service damage in power plant componentsEngineering Failure Analysis, 2007
- New low alloy heat resistant ferritic steels T/P23 and T/P24 for power plant applicationInternational Journal of Pressure Vessels and Piping, 2007