Optimizing Ferrotitanium Wire Injection Parameters for Improving Titanium Recovery in Ladle Furnace Steelmaking
- 16 March 2024
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 96 (4)
Abstract
Titanium or niobium alloying is done in microalloyed steels to improve the mechanical properties by grain refinement. Contrary to niobium, titanium addition gives additional advantages of 1) lower rolling load in the mill and 2) low ferroalloy cost. However, recovery of titanium, owing to its high affinity toward oxygen, is highly inconsistent and depends mainly on secondary steelmaking process parameters like dissolved oxygen content in steel, chemical composition of slag, addition method of alloy, fluid flow conditions of the bath during and after the addition of alloy and temperature of steel. Herein, process data have been analyzed and correlated to the chemical composition of steel and slag to understand the influence of various process parameters on titanium yield. Industrial plant trials have been conducted with a modified ferrotitanium (FeTi) addition practice. FeTi wire injection is done in seven heats with different wire injection speed and bottom argon purging rate. It has been found that 200 m min−1 of injection speed along with differential flow rate of argon from porous plugs with 35 and 6 Nm3 h−1, respectively, yields better recovery of titanium. The titanium recovery increases by 4% compared to the earlier practice of wire injection and argon purging.Keywords
This publication has 12 references indexed in Scilit:
- A Computational Fluid Dynamics‐Thermodynamics Coupled Approach to Simulate Desulfurization in Ladle Furnace Based on Interface Equilibrium AssumptionSteel Research International, 2023
- Influence of refining process and utilization of different slags on inclusions, titanium yield and total oxygen content of Ti-stabilized 321 stainless steelJournal of Iron and Steel Research International, 2020
- Numerical simulation of modification of non-metallic inclusions by calcium treatment in the argon-stirred ladleMetallurgical Research & Technology, 2019
- Titanium Microalloyed Steel: Fundamentals, Technology, and Products2019
- Modeling of the Effect of the Gas Flow Rate on the Fluid Flow and Open‐Eye Formation in a Water Model of a Steelmaking LadleSteel Research International, 2018
- Titanium microalloyed steelsIronmaking & Steelmaking: Processes, Products and Applications, 2018
- Influence of ferroalloy impurities and ferroalloy addition sequence on ultra low carbon (ULC) steel cleanliness after RH treatmentIronmaking & Steelmaking: Processes, Products and Applications, 2012
- Numerical Simulation of Fluid Flow and Interfacial Behavior in Three‐phase Argon‐Stirred Ladles with One Plug and Dual PlugsSteel Research International, 2011
- Ferroalloy quality and steel cleanlinessIronmaking & Steelmaking: Processes, Products and Applications, 2010
- Improvement in LF Process Through Optimization of Dual Porous Plugs Location in Gas Stirred LadlesMaterials and Manufacturing Processes, 2010