An open-loop stepper motor driver based on FPGA
Authors:
- 1 January 2007
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1322-1326
Abstract
In motion control systems, stepper motors are widely used and the stepper motor driver is mainly implemented using a DSP (digital signal processor). Using the DSP allows the control algorithm to be easily applied. Both coding and debugging processes can be rapidly performed. The DSP based driver's exhibit good performance; they are reliable, precise, and responsive. However, when mass production is needed, FPGA (field-programmable gate array) based drivers are preferred since the FPGA based design is compatible with conversation to an ASIC (application specific integrated circuit). Previous studies proposed FPGA based drivers but the quality is still limited because of the difficulty of handling complex computations in the FPGA. Nowadays, with the improvement of FPGA techniques, it is possible to perform various computations in the FPGA so it can be used instead of the DSP in motor driver design. This paper presents an open loop driver based on the FPGA. This driver can perform stable, precise control and is responsive. The experimental results verify the performance of the control driver algorithm.Keywords
This publication has 5 references indexed in Scilit:
- Development of an FPGA-Based Motion Control ASIC for Robotic Manipulators2006
- Implementation of complete AC Servo control in a low cost FPGA and subsequent ASSP conversion2004
- Analysis of the unipolar PWM techniques2002
- A PWM voltage source inverter with PI controller for instantaneous motor current control2002
- Improved digital current control methods in switched reluctance motor drivesIEEE Transactions on Power Electronics, 1999