Fabrication of preferentially oriented Al4043 alloy and its wear anisotropy
- 1 December 2020
- journal article
- research article
- Published by Elsevier in Materials Letters
- Vol. 280, 128578
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- Printability of multiwalled SS 316L by wire arc additive manufacturing route with tunable textureMaterials Letters, 2020
- Comparative study of microstructure evaluation and mechanical properties of 4043 aluminum alloy fabricated by wire-based additive manufacturingMaterials & Design, 2020
- Wear anisotropy of selective laser melted 316L stainless steelWear, 2019
- Influence of contact area on the sliding friction and wear behaviour of an electrochemical jet textured Al-Si alloyWear, 2019
- Effect of titanium powder on microstructure and mechanical properties of wire + arc additively manufactured Al-Mg alloyMaterials Letters, 2019
- Cold metal transfer (CMT) technology - An overviewDefence Technology, 2018
- Microstructure and strength analysis of eutectic Al-Si alloy in-situ manufactured using selective laser melting from elemental powder mixtureJournal of Alloys and Compounds, 2017
- Wear behavior and microstructure of hypereutectic Al-Si alloys prepared by selective laser meltingApplied Surface Science, 2016
- Forming appearance control of arc striking and extinguishing area in multi-layer single-pass GMAW-based additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2016