Microenvironment Created by SnSe2 Vapor and Pre‐Selenization to Stabilize the Surface and Back Contact in Kesterite Solar Cells
Authors:
Abstract
The ambient air‐processed preparation of kesterite Cu2ZnSn(S,Se)4 (CZTSSe) thin film is highly promising for the fabrication of low‐cost and eco‐friendly solar cells. However, the Sn volatilization loss and formation of a thick Mo(S,Se)2 interfacial layer during the traditional selenization process pose challenges for fabricating high‐efficiency CZTSSe solar cells. Here, CZTS precursors prepared by a sol‐gel process in ambient air are selenized and assisted with SnSe2 vapor via one‐ and two‐step selenization to prepare a CZTSSe absorber on a Mo film and, subsequently, solar cells. For one‐step selenization, the thickness of the fine grain and Mo(S,Se)2 layers near the back contact can be significantly reduced with increasing SnSe2 vapor partial pressure in the mixed selenization atmosphere, while the device efficiency is only 7.97% due to the severe interface recombination. For two‐step selenization, the desired morphology and stoichiometry of the absorber can be achieved through the assistance of Sn‐poor precursors selenized with high SnSe2 vapor partial pressure to regulate the Sn content in CZTSSe, yielding the highest efficiency of 10.85%. This study improves the understanding of the key role of the microenvironment during film growth towards the production of high‐efficiency thin film solar cells and other photoelectronic devices.Keywords
Funding Information
- National Natural Science Foundation of China (U1902218)
This publication has 75 references indexed in Scilit:
- On the kinetics of MoSe2 interfacial layer formation in chalcogen-based thin film solar cells with a molybdenum back contactApplied Physics Letters, 2013
- Classification of Lattice Defects in the Kesterite Cu2ZnSnS4 and Cu2ZnSnSe4 Earth‐Abundant Solar Cell AbsorbersAdvanced Materials, 2013
- A Detrimental Reaction at the Molybdenum Back Contact in Cu2ZnSn(S,Se)4 Thin-Film Solar CellsJournal of the American Chemical Society, 2012
- The Role of Sulfur in Solution‐Processed Cu2ZnSn(S,Se)4 and its Effect on Defect PropertiesAdvanced Functional Materials, 2012
- Thermodynamic Aspects of the Synthesis of Thin‐Film Materials for Solar CellsChemphyschem, 2012
- Chemical Insights into the Instability of Cu2ZnSnS4 Films during AnnealingChemistry of Materials, 2011
- Interpretation of admittance, capacitance-voltage, and current-voltage signatures in Cu(In,Ga)Se2 thin film solar cellsJournal of Applied Physics, 2010
- Investigation of the Saturated Vapor Pressure of Zinc, Selenium, and Zinc SelenideGlass Physics and Chemistry, 2005
- Thin‐film solar cells: device measurements and analysisProgress in Photovoltaics: Research and Applications, 2004
- Equilibrium sublimation and thermodynamic properties of SnSe and SnSe2Zeitschrift für anorganische und allgemeine Chemie, 1983