Multi-objective parameters optimization design of self-excited oscillation pulsed atomizing nozzle
Authors:
Open Access
- 25 October 2019
- journal article
- research article
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 41 (11) , 510
Abstract
The self-excited oscillation pulsed atomizing nozzle can effectively and evenly spray the high-speed solid cone jet without any extra power. The primary atomization of the jet at the outlet of nozzle directly affects the final spray quality, and the turbulence and cavitation at the outlet of the atomizing nozzle are the other two main factors affecting the atomization. In this work, multi-objective optimization depending on nozzle parameters was established by using mathematical optimization techniques and computational fluid dynamics to improve the jet atomization quality at the outlet of the nozzle. The central composite design method and the response surface method were used to obtain the approximate mathematical model of the primary atomization quality of the jet at the outlet of nozzle. Finally, the non-dominated sorting genetic algorithm with elitist strategy (NSGA-II) and the grey theory were used in combination to optimize the nozzle parameters. Through combining with the NSGA-II and the grey theory, the nozzle parameters were optimized in order to obtain the best primary atomization at the outlet area of nozzle. The optimization results verified the nozzle design with multi-objective optimization method. The optimized values of the turbulent kinetic energy F1 and the vapor volume fraction F2 increased by 28.26% and 5.56%, respectively, and the corresponding nozzle parameters of the chamber diameter D, the lower nozzle diameter d2 and the upper nozzle inlet pressure Pin were, respectively, optimized to 28.056 mm, 5.472 mm and 3.999 Mpa.Keywords
Funding Information
- National Natural Science Foundation of China (51875419, 51405352)
This publication has 25 references indexed in Scilit:
- Diesel nozzle geometries on spray characteristics with a spray model coupled with nozzle cavitating flowInternational Journal of Automotive Technology, 2015
- Multi-objective optimization of nanofluid flow in flat tubes using CFD, Artificial Neural Networks and genetic algorithmsAdvanced Powder Technology, 2014
- Effects of the number of tangential passages on spray characteristics of a bipropellant atomizerJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2013
- Numerical study on the effect of the injection pressure on spray penetration lengthApplied Mathematical Modelling, 2013
- Analysis by droplet size classes of the liquid flow structure in a pressure swirl hollow cone sprayChemical Engineering and Processing - Process Intensification, 2010
- Wall-layer models for large-eddy simulationsProgress in Aerospace Sciences, 2008
- Comparison of a Low Diffusion E-CUSP and the Roe Scheme for RANS Calculation2008
- CFD‐based multi‐objective optimization method for ship designInternational Journal for Numerical Methods in Fluids, 2006
- A Fast Elitist Non-dominated Sorting Genetic Algorithm for Multi-objective Optimization: NSGA-II2000
- Increase of the Atomization of a Liquid Jet by Cavitation in a Nozzle Hole.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B, 1997