IMPLEMENTACIÓN EN FPGA DE UN CLASIFICADOR DE MOVIMIENTOS DE LA MANO USANDO SEÑALES EMG
Open Access
- 5 September 2015
- journal article
- Published by Universidad Distrital Francisco Jose de Caldas in Redes de Ingeniería
- Vol. 6 (1) , 85-94
Abstract
Este trabajo presenta el diseño e implementación de un clasificador de señales electromiográficas (EMG) para tres movimientos de la mano: flexión, extensión y cierre, usando dos músculos del antebrazo, palmar largo y extensor común de los dedos. El desarrollo comprende dos bloques principales, el hardware para la adquisición y adecuación de la señales EMG analógicas y el sistema de procesamiento para la identificación y clasificación del movimiento realizado; el sistema completo fue implementado en hardware usando un kit de desarrollo DE2-70 que cuenta con un FPGA Cyclone II de Altera. Para la extracción de características se implementó la Transformada Rápida de Fourier (FFT), para cada canal, a la cual se le calcularon técnicas de procesamiento como la varianza y el promedio.. Finalmente, se establece un umbral de decisión para identificar el movimiento realizado. El tiempo de respuesta del sistema total fue de 17,7 us, obteniendo una tasa de identificación mayor al 87%. FPGA implementation of a hand motions classifier using EMG signals Abstract This paper presents the design and implementation of a hand motions classifier using electromyographic (EMG) signals. The classified motions are: wrist flexion, wrist extension and hand closure. The motions are classified using two forearm muscles: longus palmar and extensor digitorum. This work was implemented in two principal blocks: the acquisition and adequacy of the EMG signal, and the processing system for the identification and classification of the motion made. The processing system was implemented on hardware using a development kit with a Cyclone II FPGA from Altera. For the feature extraction the Fast Fourier Transform (FFT) is performed at each channel and some features like variance and mean are calculated. Finally, a threshold decision block is used to identify the motion. The system have a time response of 17,7 us, obtaining an identification rate higher than 87%. Keywords: EMG signals, FPGA, motion classifier, real time.Keywords
This publication has 4 references indexed in Scilit:
- The Extraction of Neural Information from the Surface EMG for the Control of Upper-Limb Prostheses: Emerging Avenues and ChallengesIEEE Transactions on Neural Systems and Rehabilitation Engineering, 2014
- Classification of Finger Movements for the Dexterous Hand Prosthesis Control With Surface ElectromyographyIEEE Journal of Biomedical and Health Informatics, 2013
- A Comparison of Surface and Intramuscular Myoelectric Signal ClassificationIEEE Transactions on Biomedical Engineering, 2007
- Classification of the myoelectric signal using time-frequency based representationsMedical Engineering & Physics, 1999