Oil foams stabilised solely by particles
- 16 December 2010
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 7 (5) , 1800-1808
Abstract
The influence of the surface tension of the liquid (γla) on the material formed upon aerating mixtures of the liquid and fluoroethylene particles is investigated. For non-polar oils of relatively low tension, an oil dispersion of particles is formed as the liquid wets the particles. For polar liquids of relatively high tension like ethylene glycol or water which do not wet the particles, a powder-like material is formed composed of drops of the liquid coated with particles dispersed in air. However, for polar oils of intermediate tension (30–45 mN m−1) which partially wet these particles, stable air-in-oil foams can be prepared in which particles form a close-packed layer enveloping air bubbles. Using five commercial poly- or oligotetrafluoroethylene particle samples, we describe the effect of particle type, oil type and particle concentration on these foams and use freeze fracture electron microscopy to observe the arrangement of particles at the air–oil surface. Using contact angle (θ) measurements on pressed tablets of the particles, the relation between γla and θ is established: particle-stabilised oil foams form for θ between ca. 40 and 90°.Keywords
This publication has 20 references indexed in Scilit:
- Non-aqueous foams in lubricating oil systemsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2010
- Polymer Foams Stabilized by Particles Adsorbed at the Air/Polymer InterfaceMacromolecular Rapid Communications, 2008
- Foaming Properties of Monoglycerol Fatty Acid Esters in Nonpolar Oil SystemsLangmuir, 2006
- Long-Range Structural Order, Moiré Patterns, and Iridescence in Latex-Stabilized FoamsJournal of the American Chemical Society, 2006
- Microstructure, Morphology, and Lifetime of Armored Bubbles Exposed to SurfactantsLangmuir, 2006
- Stabilisation of liquid metallic foams by solid particlesColloids and Surfaces A: Physicochemical and Engineering Aspects, 2005
- Aqueous Foams Stabilized Solely by Silica NanoparticlesAngewandte Chemie International Edition, 2005
- Foam Superstabilization by Polymer MicrorodsLangmuir, 2004
- Particles as surfactants—similarities and differencesCurrent Opinion in Colloid & Interface Science, 2002
- Thin-film forces in hydrocarbon foam films and their application to gas-blocking foams in enhanced oil recoveryColloids and Surfaces A: Physicochemical and Engineering Aspects, 1997