Development of Highly Efficient Energy Harvester Based on Magnetic Field Emanating From a Household Power Line and Its Autonomous Interface Electronics
- 16 February 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (7) , 6607-6615
Abstract
A magnetic energy harvester and its interface electronics are developed to operate a surface acoustic wave (SAW) oscillator sensor that requires at least 5 to 6 V DC (50 ~ 100 mW) to drive and transmit the measured sensor signals to the reader system wirelessly via antennas. The developed energy harvester system comprises a magnetic energy harvester with a coil wound around a magnetic core, an energy storage interface, and a power management interface. From a 220 V, 3 A household AC power line, a 12 V DC is harvested in the storage capacitor via a 5 min energy scavenging process to activate the SAW oscillator sensor. After 2 min of operation using the sensor system, the power management interface is completely shut down to recharge the storage capacitor and then restarted after sufficient charges are accumulated in the storage capacitor to reoperate the SAW oscillator sensor. This autonomous sequence is continuously repeated. The entire interface electronics is developed on a single printed circuit board to reduce the energy loss by the board and to facilitate installation in the desired applications. A simulation is performed in COMSOL to determine the optimal energy harvester parameters and to predict the magnetic flux density that forms the induced current around the ferrite magnetic core based on the magnetic core shape. Experimental results show that the developed energy harvester system can harvest sufficient energy from the household power line in a short period to operate the complex RF SAW sensor and the sensor interface electronics. Furthermore, it can be used to operate the SAW oscillator sensor for the time required to obtain valid information to be transmitted wirelessly to the reader system.Keywords
Funding Information
- Korea Electric Power Corporation (R22XO02-17)
- Ministry of SMEs and Startups of Korea (S2966214)
This publication has 34 references indexed in Scilit:
- Design and experimental investigation of a low-voltage thermoelectric energy harvesting system for wireless sensor nodesEnergy Conversion and Management, 2017
- Non‐intrusive voltage measurement of ac power lines for smart grid system based on electric field energy harvestingElectronics Letters, 2017
- Optimization Design of an Inductive Energy Harvesting Device for Wireless Power Supply System Overhead High-Voltage Power LinesEnergies, 2016
- Real-Time QoS Routing Protocols in Wireless Multimedia Sensor Networks: Study and AnalysisSensors, 2015
- Low-intensity ultraviolet detection using a surface acoustic-wave sensor with a Ag-doped ZnO nanoparticle filmSmart Materials and Structures, 2014
- A Smart Sensor Network for Sea Water Quality MonitoringIEEE Sensors Journal, 2014
- Design and implementation of smart home energy management systems based on zigbeeIEEE Transactions on Consumer Electronics, 2010
- Comparative study of heat transfer from Nb-Ti andcoils to He IIPhysical Review Special Topics - Accelerators and Beams, 2008
- Biocompatible benzocyclobutene-based intracortical neural implant with surface modificationJournal of Micromechanics and Microengineering, 2005
- Characterization of Ni–Cu mixed spinel ferriteJournal of Magnetism and Magnetic Materials, 2002