A Study of the Stability Mechanism of the Dispersed Particle Gel Three-Phase Foam Using the Interfacial Dilational Rheology Method
Open Access
Abstract
The dispersed particle gel (DPG) three-phase foam is a novel profile control and flooding system. The stability mechanism of the DPG three-phase foam was studied using an interfacial dilational rheology method. The results show that the elastic modulus of the DPG three-phase foam is up to 14 mN/m, which is much higher than the traditional foam. The increase in interface elasticity produces significantly positive effects on foam stability. Emphasis is given to the influences of frequency, temperature, pressure, and concentration on the viscoelasticity and interfacial adsorption of DPG particles, which change the modules of the foam interface and have a significant effect on foam stability. In addition, the microstructure of the DPG three-phase foam was observed. A viscoelastic shell is formed by the aggregation of the DPG particles on the interface. The irreversible adsorption gives the interface high elasticity and mechanical strength. The electrostatic repulsion between particles increases the spacing between bubbles. The combined effects of these factors give the interface higher mechanical strength, slow down the film drainage, effectively prevent gas permeation, and significantly improve the foam stability.Keywords
Funding Information
- The National Key Basic Research Program (No. 2015CB250904)
- Science Funds for Doctoral fund of Shandong Province (No. ZR201702170502)
- China Postdoctoral Fund (No. 2016M602228)
This publication has 29 references indexed in Scilit:
- An experimental study of nanoparticle-polymer-stabilized CO 2 foamColloids and Surfaces A: Physicochemical and Engineering Aspects, 2017
- Stability mechanism of a novel three-Phase foam by adding dispersed particle gelColloids and Surfaces A: Physicochemical and Engineering Aspects, 2016
- Dilational rheological properties of interfacial films containing Branch‐Preformed particle gel and crude oil fractionsJournal of Applied Polymer Science, 2014
- Effect of oil on the stability of polymer enhanced foamsInternational Journal of Oil, Gas and Coal Technology, 2013
- Interfacial rheology of protein–surfactant mixturesCurrent Opinion in Colloid & Interface Science, 2010
- Origin of stabilisation of aqueous foams in nanoparticle–surfactant mixturesSoft Matter, 2008
- Stabilization of bubbles and foamsCurrent Opinion in Colloid & Interface Science, 2007
- Shear and Dilational Surface Rheology of Oppositely Charged Polyelectrolyte/Surfactant Microgels Adsorbed at the Air−Water Interface. Influence on Foam StabilityThe Journal of Physical Chemistry B, 2004
- A Neutron Reflectivity Study of Poly(N-isopropylacrylamide) at the Air−Water Interface with and without Sodium Dodecyl SulfateMacromolecules, 2000
- Characterisation of adsorbed polymer film structure by dynamic surface tension and dilational elasticityColloids and Surfaces A: Physicochemical and Engineering Aspects, 1999