Highly sensitive compression sensors using three-dimensional printed polydimethylsiloxane/carbon nanotube nanocomposites
- 18 March 2019
- journal article
- research article
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 30 (8) , 1216-1224
Abstract
This article presents three-dimensional printed and highly sensitive polydimethylsiloxane/multi-walled carbon nanotube sensors for compressive strain and pressure measurements. An electrically conductive polydimethylsiloxane/multi-walled carbon nanotube nanocomposite is developed to three-dimensional print compression sensors in a freestanding and layer-by-layer manner. The dispersion of multi-walled carbon nanotubes in polydimethylsiloxane allows the uncured nanocomposite to stand freely without any support throughout the printing process. The cross section of the compression sensors is examined under scanning electron microscope to identify the microstructure of nanocomposites, revealing good dispersion of multi-walled carbon nanotubes within the polydimethylsiloxane matrix. The sensor’s sensitivity was characterized under cyclic compression loading at various max strains, showing an especially high sensitivity at lower strains. The sensing capability of the three-dimensional printed nanocomposites shows minimum variation at various applied strain rates, indicating its versatile potential in a wide range of applications. Cyclic tests under compressive loading for over 8 h demonstrate that the long-term sensing performance is consistent. Finally, in situ micromechanical compressive tests under scanning electron microscope validated the sensor’s piezoresistive mechanism, showing the rearrangement, reorientation, and bending of the multi-walled carbon nanotubes under compressive loads, were the main reasons that lead to the piezoresistive sensing capabilities in the three-dimensional printed nanocomposites.Keywords
This publication has 34 references indexed in Scilit:
- Mechanical characterization of bulk Sylgard 184 for microfluidics and microengineeringJournal of Micromechanics and Microengineering, 2014
- Highly Stretchable Piezoresistive Graphene–Nanocellulose Nanopaper for Strain SensorsAdvanced Materials, 2013
- Strain sensing behaviour of elastomeric composite films containing carbon nanotubes under cyclic loadingComposites Science and Technology, 2013
- Tunneling resistance and its effect on the electrical conductivity of carbon nanotube nanocompositesJournal of Applied Physics, 2012
- Integrating stereolithography and direct print technologies for 3D structural electronics fabricationRapid Prototyping Journal, 2012
- Highly sensitive flexible pressure sensors with microstructured rubber dielectric layersNature Materials, 2010
- Effect of processing conditions on the bonding quality of FDM polymer filamentsRapid Prototyping Journal, 2008
- Giant Dielectric Permittivities in Functionalized Carbon‐Nanotube/ Electroactive‐Polymer NanocompositesAdvanced Materials, 2007
- Electrical and mechanical behavior of filled elastomers. I. The effect of strainJournal of Polymer Science Part B: Polymer Physics, 2003
- Use of stereolithography to manufacture critical‐sized 3D biodegradable scaffolds for bone ingrowthJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2002