In Vitro Frictional Forces Generated by Three Different Ligation Methods
Authors:
- 1 September 2008
- journal article
- Published by The Angle Orthodontist (EH Angle Education & Research Foundation) in The Angle Orthodontist
- Vol. 78 (5) , 917-921
Abstract
Objective: To test the hypothesis that there is no difference between the frictional forces produced by a passive self-ligating bracket (SLB) in vitro and a conventional bracket (CB) used with two types of elastomeric ligatures. Materials and Method: The brackets, wires and ligation methods used in vitro were a passive SLB and a CB used with two types of elastomeric ligatures (conventional elastomeric ligature [CEL] and unconventional elastomeric ligatures [UEL]). The bracket ligation systems were tested with two types of wires (0.014″ super elastic nickel titanium wire and 0.019″ × 0.025″ stainless steel wire). Resistance to sliding of the bracket/wire/ligature systems was measured with an experimental model mounted on the crosshead of an Instron testing machine with a 10 N load cell. Each sample was tested 10 consecutive times under a dry state. Results: Frictional forces close to 0 g were recorded in all tests with SLB and in all tests with UEL on CB with both wire types. Resistance to sliding increased significantly (87–177 g) (P < .05) when CEL on CB was used with both wires. Conclusion: UELs may represent a valid alternative to passive SLBs for low-friction biomechanics.Keywords
This publication has 28 references indexed in Scilit:
- Friction: an overviewSeminars in Orthodontics, 2003
- Friction between different wire-bracketconfigurations and materialsSeminars in Orthodontics, 1997
- Frictional resistances in stainless steel bracket-wire combinations with effects of vertical defectionsAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1996
- The Ex Vivo Effect of Ligation Technique on the Static Frictional Resistance of Stainless Steel Brackets and ArchwiresBritish Journal of Orthodontics, 1995
- A Study of Frictional Forces between Orthodontic Brackets and ArchwiresBritish Journal of Orthodontics, 1994
- Evaluation of friction between ceramic brackets and orthodontic wires of four alloysAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1990
- Evaluation of friction between edgewise stainless steel brackets and orthodontic wires of four alloysAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1990
- Frictional forces between bracket and arch wireAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1989
- A comparative study of frictional resistances between orthodontic bracket and arch wireAmerican Journal of Orthodontics, 1980
- Evaluation of friction forces in the 0·022 × 0·028 edgewise bracket in vitroJournal of Biomechanics, 1970