Determining the strength of 3D printed concrete with the modified slant shear test
Open Access
- 12 January 2025
- journal article
- research article
- Published by Wiley in Structural Concrete
- Vol. 26 (3) , 2467-2486
Abstract
This study deals with the assessment of the load‐bearing capacity of layered 3D printed concrete (3DPC) using a modified slant shear test (MSST) to define a Mohr's envelope. To this aim, the established modified Coulomb yield condition of the concrete is complemented by a Coulomb failure criterion of the layer joints (cold or dry joints). Due to the anisotropy inherent to 3DPC elements, caused by the interlayer of printed concrete, the test setups commonly used for conventional concrete are inadequate to assess the load‐bearing capacity of 3DPC. A total of 45 3DPC specimens with different inclinations of the concrete printed layers, including a cold joint with 30 min time gap were tested using the MSST. The results showed a high strength of the interfaces with two different failure modes, depending on the inclination of the layers: (i) concrete matrix failure and (ii) layer interface failure, where the latter governed for layer inclinations of 60° and 75° with respect to the horizontal plane. The test campaign confirms that the proposed MSST is a highly practical test method that enables determining the parameters governing a Mohr's envelope of layered 3DPC and can thus be used to reliably characterize its load‐bearing capacity.Keywords
Funding Information
- Schweizerischer Nationalfonds zur Förderung der Wissenschaftlichen Forschung
- Università degli Studi di Brescia
This publication has 45 references indexed in Scilit:
- Structural Testing Campaign for a 30 m Tall 3D Printed Concrete Tower2024
- A 3D Printing Platform for Reinforced Printed-Sprayed Concrete Composites2022
- Pre-installed Reinforcement for 3D Concrete Printing2022
- Properties and Testing of Printed Cement-Based Materials in Hardened State2022
- Aligned Interlayer Fibre Reinforcement and Post-tensioning as a Reinforcement Strategy for Digital Fabrication2020
- Fresh and Hardened Properties of 3D High-Strength Printing Concrete and Its Recent ApplicationsIranian Journal of Science and Technology, Transactions of Civil Engineering, 2020
- 3D Printing Concrete with Reinforcement2017
- Theory of Structures2013
- Strain-softening of concrete in uniaxial compressionMaterials and Structures, 1997
- Experimental investigation of concrete fracture under uniaxial compressionMechanics of Cohesive-frictional Materials, 1996