A theoretical analysis of non‐isothermal flow in wire‐coating co‐extrusion dies
Author:
- 1 December 1981
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 21 (17) , 1128-1138
Abstract
A theoretical study of non‐isothermal superimposed flow of two polymer melts in wire coating co‐extrusion dies has been carried out. Numerical methods have been employed to solve the coupled momentum‐ and energy‐balance equations. Various combinations of three polymers—namely, high density polyethylene (HDPE), polystyrene (PS) and low density polyethylene (LDPE) have been studied and least squares curve fitted quadratic polynomials have been used for constitutive equations for all three polymers in non‐Newtonian high shear rate regions. A multitude of thermal and mechanical boundary conditions can be treated by this algorithm. It was found that temperature and velocity profiles in the die depend significantly on the arrangement of the polymers. Maximum temperature rise has been noted to increase sharply with wire velocity but it can be reduced by increasing the die radius. When the thickness of the outer layer is increased from zero, the shear stress at the wall undergoes a dramatic change (if the viscosities of the polymers are different) at small values of the flow rate ratio and it reaches an asymptotic value at large values of flow rate ratio. It was also found that viscosity ratio at the interface can be reduced by changing the initial temperatures of the liquids. It was observed in some cases that large errors in the calculation of rheological and thermal variables for this problem can be made if temperature rise due to viscous dissipation is not considered.Keywords
This publication has 17 references indexed in Scilit:
- Experimental and theoretical investigation of extrudate swell of polymer melts from small (length)/(cross‐section) ratio slit and capillary diesPolymer Engineering & Science, 1980
- Studies on wire coating extrusion. II. The rheology of wire coating coextrusionPolymer Engineering & Science, 1980
- Realistic analysis of flow in wire‐coating diesPolymer Engineering & Science, 1979
- THE USE OF KETAMINE HYDROCHLORIDE FOR ENDOTRACHEAL INTUBATION IN CATTLEAustralian Veterinary Journal, 1979
- Molecular Weight Effects in Die Swell and in Shear RheologyJournal of Rheology, 1979
- Studies on wire coating extrusion. I. The rheology of wire coating extrusionPolymer Engineering & Science, 1978
- Studies on multilayer film coextrusion II. Interfacial instability in flat film coextrusionPolymer Engineering & Science, 1978
- Stratified two‐phase flog of molten polymers in circular diesPolymer Engineering & Science, 1977
- Studies on multilayer film coextrusion I. The rheology of flat film coextrusionPolymer Engineering & Science, 1976
- Theory of Interface Distortion in Stratified Two-Phase FlowTransactions of the Society of Rheology, 1975