Motion Characteristics of Discharge Channel in WEDM
Authors:
- 9 December 2020
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 36 (5) , 583-598
Abstract
Discharge channel motion characteristics are one of the focuses of electrical discharge machining (EDM) mechanism research. Based on single pulse discharge experiments, discharge channel motion laws of wire-cut EDM (WEDM) under different electrical parameters were researched. Results show that discharge channel motion speeds are highest at the beginning of the discharge, then drop sharply, and finally enter a relatively stable state, due to the current density change, pressure difference change between the inside and outside of the discharge channel, and the electrode wire shape itself. When discharge time lasts from 0.5 μs to 5 μs, the discharge channel average moving speed drops by about 60%, and when discharge time lasts about 15–25 μs, the discharge channel diameter expands to the maximum. Continuous machining experiment reveals that the variation laws of both cutting efficiency and a single discharge crater surface area with electrical parameters are consistent, that is, the motion laws of a single pulse discharge channel can microcosmically reveal cutting efficiency variation laws in WEDM macroscopically. Improving cutting efficiency only by increasing pulse energy (especially pulse width) is difficult. In high-speed WEDM (HSWEDM) process, the pulse width exceeding 75 μs is proved to have little effect on cutting efficiency improvement.Keywords
Funding Information
- National Natural Science Foundation of China
This publication has 20 references indexed in Scilit:
- Observation analysis of arc plasma channel developing and expansion behavior in single arc dischargingProcedia Manufacturing, 2018
- The Discharge Channel Formation and the Mechanism of Material Removal During Electrical Discharge Micromachining by Nanosecond PulsesProcedia CIRP, 2018
- Simulation of the Motion of Charged Particles in an Ablative Pulsed Plasma Thruster at the Initial Stage of the DischargeProcedia Engineering, 2017
- Study on decreasing tool wear in EDM due to arc spots sliding on electrodesPrecision Engineering, 2010
- A review on current research trends in electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2007
- After 60 years of EDM the discharge process remains still disputedJournal of Materials Processing Technology, 2004
- Theoretical models of the electrical discharge machining process. III. The variable mass, cylindrical plasma modelJournal of Applied Physics, 1993
- Observation of Arc Column Movement during Monopulse Discharge in EDMCIRP Annals, 1992
- Theoretical models of the electrical discharge machining process. II. The anode erosion modelJournal of Applied Physics, 1989
- Theoretical models of the electrical discharge machining process. I. A simple cathode erosion modelJournal of Applied Physics, 1989