Design methods for time-domain equalizers in DMT transceivers
Authors:
- Ming DingMDMing Ding
- 1 March 2001
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 49 (3) , 554-562
Abstract
Time-domain equalizers (TEQ) are used in the discrete multitone (DMT) transceivers in order to reduce the duration of the overall response of the transmission system, so that a shorter-length cyclic prefix could be used. The optimum TEQ is the one that results in maximum bit allocation to each block of the DMT. However, the optimum design of TEQs turns out to be a very difficult task. We give the general guidelines that one should follow in the design of TEQ to achieve a good performance. Based on the suggested guidelines, we first propose an eigenapproach design method which results in TEQs with comparable performance to those of a previously reported method, but at a much lower computational cost. Further study of the proposed guidelines reveals that the choice of target-impulse response in the design of TEQ only weakly depends on the channel response. Noting this, we propose a second design method that is even simpler than our first method, but still results in comparable designs to those of our first method and also those obtained from the much more complex methods of the present literature.Keywords
This publication has 6 references indexed in Scilit:
- Bandwidth optimization for high speed data transmission over channels with severe intersymbol interference2003
- A bandwidth-optimized reduced-complexity equalized multicarrier transceiverIEEE Transactions on Communications, 1997
- Optimum finite-length equalization for multicarrier transceiversIEEE Transactions on Communications, 1996
- Digital Communication1994
- The HDSL environment (high bit rate digital subscriber line)IEEE Journal on Selected Areas in Communications, 1991
- Adaptive Channel Memory Truncation for Maximum Likelihood Sequence EstimationBell System Technical Journal, 1973