The effect of epoxy coating on the fatigue strength of grade-A mild steel
- 15 October 2021
- journal article
- research article
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 36 (17) , 1847-1857
Abstract
In this study, tension fatigue tests of grade-A marine mild steel with epoxy type of coating were carried out and the corresponding S–N curves with a survival probability of 97.5% are derived. Compared to the uncoated specimens studied previously, Epoxy coating has increased fatigue life of Mild steels by about 50% in the case of high cycle fatigue and fatigue limit by 6%. This improvement on fatigue strength is mainly due to crack-tip bridging phenomenon of coating which fills micro surface cracks and delayed surface crack propagation. The effect of surface finishing method on adhesion strength of Epoxy coating is investigated by pull-off tests. The DIC method is used to determine the in-plane strain distribution in the necking region of tensile test of uncoated specimens. The final image before fracture shows that the vertical and horizontal local strain in the necking position is 155 and 32%, respectively.Keywords
This publication has 31 references indexed in Scilit:
- Fatigue crack initiation and damage characterization in Brazilian test specimens for adhesive jointsJournal of Adhesion Science and Technology, 2012
- Mechanical characterization and damage assessment of thick adhesives for wind turbine blades using acoustic emission and digital image correlation techniquesJournal of Adhesion Science and Technology, 2012
- Assessment of the fatigue life of aluminium spot-welded and weld-bonded jointsJournal of Adhesion Science and Technology, 2012
- A Review of the Fatigue Behaviour of Components Coated with Thin Hard Corrosion-Resistant CoatingsThe Open Corrosion Journal, 2011
- Tensile strength of glass fibres with carbon nanotube–epoxy nanocomposite coatingComposites Part A: Applied Science and Manufacturing, 2009
- The effect of coating thickness on the thermal conductivity of EB-PVD PYSZ thermal barrier coatingsSurface and Coatings Technology, 2006
- Investigation of coating failure on the surface of a water ballast tank of an oil tankerJournal of Adhesion Science and Technology, 2005
- Adhesion measurement procedures for kinetic and thermal spray coatings using a stud-pull testerJournal of Adhesion Science and Technology, 2004
- Effect of polymeric structure on the corrosion protection of epoxy coatingsCorrosion Science, 2002
- Degradation of epoxy coatings in humid environments: the critical relative humidity for adhesion lossJournal of Adhesion Science and Technology, 1991