The Effects of Operating Conditions on the Performance of a Solid Oxide Steam Electrolyser: A Model‐Based Study
- 9 November 2010
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 10 (6) , 1114-1128
Abstract
To support the development of hydrogen production by high temperature electrolysis using solid oxide electrolysis cells (SOECs), the effects of operating conditions on the performance of the SOECs were investigated using a one‐dimensional model of a cathode‐supported planar SOEC stack. Among all the operating parameters, temperature is the most influential factor on the performance of an SOEC, in terms of both cell voltage and operation mode (i.e. endothermic, thermoneutral and exothermic). Current density is another influential factor, in terms of both cell voltage and operation mode. For the conditions used in this study it is recommended that the SOEC be operated at 1,073 K and with an average current density of 10,000 A m–2, as this results in the stack operating at almost constant temperature along the cell length. Both the steam molar fraction at the inlet and the steam utilisation factor have little influence on the cell voltage of the SOEC but their influence on the temperature distribution cannot be neglected. Changes in the operating parameters of the SOEC can result in a transition between endothermic and exothermic operation modes, calling for careful temperature control. The introduction of air into the anode stream appears to be a promising approach to ensure small temperature variations along the cell.Keywords
This publication has 23 references indexed in Scilit:
- Nuclear heat for hydrogen production: Coupling a very high/high temperature reactor to a hydrogen production plantProgress in Nuclear Energy, 2009
- Solid oxide proton conducting steam electrolysersSolid State Ionics, 2008
- Hydrogen production through steam electrolysis: Control strategies for a cathode-supported intermediate temperature solid oxide electrolysis cellJournal of Power Sources, 2008
- Hydrogen production through steam electrolysis: Model-based dynamic behaviour of a cathode-supported intermediate temperature solid oxide electrolysis cellJournal of Power Sources, 2008
- Hydrogen production through steam electrolysis: Model-based steady state performance of a cathode-supported intermediate temperature solid oxide electrolysis cellJournal of Power Sources, 2007
- A modeling study on concentration overpotentials of a reversible solid oxide fuel cellJournal of Power Sources, 2006
- Heat transfer problems for the production of hydrogen from geothermal energyEnergy Conversion and Management, 2006
- Anode-supported intermediate-temperature direct internal reforming solid oxide fuel cellJournal of Power Sources, 2005
- Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performanceJournal of Power Sources, 2004
- Hybrid solar high-temperature hydrogen production systemInternational Journal of Hydrogen Energy, 2000