Rapid and Scalable Fabrication of Low Impedance, 3D Dry Electrodes for Physiological Sensing
Authors:
Open Access
- 17 May 2022
- journal article
- research article
- Published by Wiley in Advanced Materials Technologies
- Vol. 7 (11)
Abstract
Medical electrophysiological sensors that can study the body and diagnose diseases depend on consistently low impedance electrode–skin interfaces. Clinical‐standard wet electrodes use hydrogels and skin abrasion to improve the interface and thus the recorded signal quality. These electrodes are challenging to self‐administer and impede in‐home care. Wearable dry electrodes are more practical; however, they show higher impedances than wet electrodes and are costly to customize. This work presents a fabrication method for rapidly producing low impedance, anatomically fit dry electrodes that do not require hydrogels. By using electroless copper and gold plating with 3D printing, biocompatible electrodes can be optimized for individuals at a fraction of the cost of existing vacuum deposition‐based techniques. Example 3D dry electrodes made with this process are evaluated alongside clinical‐standard devices in typical scenarios to compare electrical performance and comfort. The resulting dry electrodes exhibit an average electrode‐skin impedance of 66.7 kΩ at 50 Hz and DC offset of −20 mV without any hydrogel, which, when area normalized, is within the range achieved by wet electrodes without skin abrasion.Keywords
All Related Versions
This publication has 24 references indexed in Scilit:
- Impedance sensing device enables early detection of pressure ulcers in vivoNature Communications, 2015
- Preventing Skin Breakdown in EEG Patients: Best Practice TechniquesJournal of Pediatric Nursing, 2014
- Dry EEG ElectrodesSensors, 2014
- A 3D printed dry electrode for ECG/EEG recordingSensors and Actuators A: Physical, 2012
- All-inkjet-printed flexible electronics fabrication on a polymer substrate by low-temperature high-resolution selective laser sintering of metal nanoparticlesNanotechnology, 2007
- Impedance Characterization and Modeling of Electrodes for Biomedical ApplicationsIEEE Transactions on Biomedical Engineering, 2005
- Conductor microstructures by laser curing of printed gold nanoparticle inkApplied Physics Letters, 2004
- Diffusion of copper into gold plating2002
- Micromachined electrodes for biopotential measurementsJournal of Microelectromechanical Systems, 2001
- The micro-determination of goldThe Analyst, 1937