Experimental Investigation and Analysis of Thrust Force in Drilling Hybrid Metal Matrix Composites by Coated Carbide Drills
Authors:
- 27 May 2011
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 26 (8) , 961-968
Abstract
Hybrid metal matrix composites (MMCs) find diversified applications in many engineering fields and are very important in the recent development of material science. The present article investigates the effect of thrust force in the drilling of hybrid MMCs using coated carbide drills. Materials used for the present investigation are Al 356-aluminum alloy reinforced with silicon carbide of size 25 microns and mica of an average size 45 microns, which are produced through stir casting route. Experiments are conducted on a vertical machining centre using the central composite design technique. A model is developed to correlate the drilling parameters with thrust force using response surface methodology (RSM). The results indicate that the developed model is suitable for prediction of thrust forces in drilling of hybrid MMCs. Analysis of the drilled surface of Al356/SiC-Mica composites was done using scanning electron microscope (SEM). The influence of different parameters on thrust force of Al356/SiC-Mica composites has been analyzed through contour graphs and three-dimensional (3D) plots.Keywords
This publication has 20 references indexed in Scilit:
- Tool Wear in Turning of Graphitic Hybrid Metal Matrix CompositesMaterials and Manufacturing Processes, 2009
- Modeling and Analysis of Machinability Evaluation in the Wire Electrical Discharge Machining (WEDM) Process of Aluminum Oxide-Based CeramicMaterials and Manufacturing Processes, 2008
- Some studies on drilling of hybrid metal matrix composites based on Taguchi techniquesJournal of Materials Processing Technology, 2008
- Electrical Discharge Machining of Functionally Graded 15–35 Vol% SiCp/Al CompositesMaterials and Manufacturing Processes, 2006
- Modeling and Optimization of Process Parameters for Defect Toleranced Drilling of GFRP CompositesMaterials and Manufacturing Processes, 2006
- Particle distribution in cast metal matrix composites—Part IJournal of Materials Processing Technology, 2002
- Investigation for controlled ellectrochemical machining through response surface methodology-based approachJournal of Materials Processing Technology, 1999
- The torque and thrust force in twist drilling—II. Comparison of experimental observations with deductions from theoryInternational Journal of Machine Tools and Manufacture, 1991
- The torque and thrust force in twist drilling—I. TheoryInternational Journal of Machine Tools and Manufacture, 1991
- The machinability of a cast aluminium alloy-graphite particle compositeMaterials Science and Engineering: A, 1988