Surface Modification and Alloying of Aluminum and Titanium Alloys with Low-Energy, High-Current Electron Beams
Authors:
Open Access
- 19 June 2011
- journal article
- review article
- Published by Hindawi Limited in Journal of Metallurgy
- Vol. 2011, 1-15
Abstract
The paper reviews the results of investigations of surface modification and alloying of Al, Ti, and its alloys with a low-energy (up to ~40 keV), high-current (up to 25 J/cm2) electron beams of microsecond duration under systematically varied conditions. The microstructural evolution of the surface layers of Al alloys (Al2024 and Al6061) and Ti-6Al-4V alloy subjected to pulsed melting as well as changes in surface-sensitive properties of these alloys are considered. Phase formation and properties of Al-based and Ti-based surface alloys, synthesized by liquid-phase mixing of multilayer film-substrate systems in wide range of solid solubility, including [Al/Si]/Al, [Al/C]/Al, [Zr/Ti]/Ti-6Al-4V, and Al/Ti, are studied. In case of Ti-based substrates, this method allows to fabricate the single-phase nanocrystalline α-(TiZr) surface alloy, free of Al and V, as well as nanosized and ultrafine grain TiAl/Ti3Al-based surface alloys of thickness ≥3 μm with enhanced mechanical properties.Keywords
This publication has 30 references indexed in Scilit:
- Synthesis of Ti3Al and TiAl based surface alloys by pulsed electron-beam melting of Al(film)/Ti(substrate) systemTechnical Physics Letters, 2011
- Surface doping of VT6 alloy with zirconium by pulsed electron-beam mixing of predeposited multilayer Zr/Ti filmTechnical Physics Letters, 2008
- Surface alloying of metallic substrates with pre-deposited films through a pulsed electron-beam mixingThe European Physical Journal Applied Physics, 2008
- Surface alloying of stainless steel 316 with copper using pulsed electron-beam melting of film–substrate systemSurface and Coatings Technology, 2006
- Surface modification and alloying of metallic materials with low-energy high-current electron beamsSurface and Coatings Technology, 2004
- Production and application of low-energy, high-current electron beamsLaser and Particle Beams, 2003
- Pulsed electron-beam melting of high-speed steel: structural phase transformations and wear resistanceSurface and Coatings Technology, 2002
- Pulsed electron-beam technology for surface modification of metallic materialsJournal of Vacuum Science & Technology A, 1998
- Use of low-energy, high-current electron beams for surface treatment of materialsSurface and Coatings Technology, 1997
- Calculation and experimental determination of dimensions of hardening and tempering zones in quenched U7A steel irradiated with a pulsed electron beamNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 1997