Modified-SST for Uniaxial Characterization of Electrical Steel Sheets Under Controlled Induced Voltage and Constant Stress
- 2 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 69 (12) , 9756-9765
Abstract
The present paper details the development of a uniaxial magneto-mechanical bench that allows measuring the effect of constant tensile and compressive stress on the magnetic properties of electrical steel sheets. Following international standards for magnetic measurements, this work proposes reasonable modifications of a Single Sheet Tester setup to provide a reliable magneto-mechanical characterization of the material. The magnetic circuit, as well as the excitation and control techniques employed are described. Specifications concerning magnetic measurements are also offered, alongside mechanical considerations regarding the anti-buckling fixture developed to allow the application of compressive stress. Finally, results obtained for various stress levels and frequencies are validated and analyzed. Among other results, the proposed bench allows observing the negative impact of compressive stress on magnetic properties of non oriented steel, as well as the positive effect of mild tensile stress.Keywords
Funding Information
- Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES) Foundation
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq) and CAPES/Comité Français d’Evaluation de la Coopération Universitaire et Scientifique avec le Brésil (COFECUB) Foundations (88881.191763/2018-01)
This publication has 31 references indexed in Scilit:
- Measurement and Analytical Modeling of the $\Delta E$Effect in a Bulk Iron-Cobalt AlloyIEEE Transactions on Magnetics, 2010
- An analytical model for the ΔEeffect in magnetic materialsThe European Physical Journal Applied Physics, 2009
- Effect of rolling on the residual stresses and magnetic properties of a 0.5% Si electrical steelJournal of Magnetism and Magnetic Materials, 2008
- A multi-coil sensor for tangential magnetic field investigationsJournal of Magnetism and Magnetic Materials, 2002
- Power losses and magnetization process in Fe–Si non-oriented steels under tensile and compressive stressJournal of Magnetism and Magnetic Materials, 2000
- Influence of the cutting process on the magnetic properties of non-oriented electrical steelsJournal of Magnetism and Magnetic Materials, 2000
- Effect of cold-rolling on magnetic properties of non-oriented silicon steel sheets (Part II)Journal of Magnetism and Magnetic Materials, 2000
- Influence of field inhomogeneity in magnetic calibration coilsIEEE Transactions on Instrumentation and Measurement, 1996
- A virtual instrument for the measurement of the characteristics of magnetic materialsIEEE Transactions on Instrumentation and Measurement, 1992
- Effects of applied stress on the magnetic properties of high permeability silicon-ironIEEE Transactions on Magnetics, 1979