Experimental notched fracture resistance study for the interface of Al–Cu bimetal joints welded by friction stir welding
- 30 January 2017
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 232 (12) , 2192-2200
Abstract
Strength and load-bearing capacity of dissimilar joints welded by friction stir welding is one of the most interesting subjects for optimizing this recently developed joining technique. Hence, in this article, dissimilar butt weldments of pure copper with Al5083 are manufactured with different welding parameters (including pin rotational and tool offset). Then rectangular beam specimens containing right angle notches in the interface of joints were prepared from the welded plates and tested under three-point bend loading to investigate the interface fracture strength of Al–Cu joints. The results showed the significant influence of welding parameters on the strength and load–displacement curves of the tested bimetals. It was shown that considering a suitable value for the offset of pin can increase the interface fracture strength. The highest fracture loads were achieved at moderately lower pin rotational speeds.Keywords
This publication has 46 references indexed in Scilit:
- A new distributed cooling method for mitigating residual stress in friction stir weldingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2016
- Development of double-side friction stir welding to improve post-welding formability of joints in AA6082 aluminium alloyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2015
- Experimental investigation of underwater friction-stir welding of 5083 marine-grade aluminum alloyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2014
- Investigations for the effect of parameters on the weld performance of AA 5083-H111 joined by friction stir weldingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Acoustic emission–based monitoring approach for friction stir welding of aluminum alloy AA6063-T6 with different tool pin profilesProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Friction stir welding parameters optimization of heterogeneous tailored welded blank sheets of aluminium alloys 6061 and 5083 using response surface methodologyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2012
- Assessment of the failure load for an AA6061-T6 friction stir spot welding jointProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2011
- Optimization of the friction-stir-welding process and tool parameters to attain a maximum tensile strength of AA7075–T6 aluminium alloyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2010
- Parametric finite element analysis of stress evolution during friction stir weldingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2006
- Friction Stir Welding of AA6082-T6 T-joints: Process Engineering and Performance MeasurementProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2006