Experimental Study on Milling CFRP with Staggered PCD Cutter
Open Access
- 11 September 2017
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 7 (9) , 934
Abstract
Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the cutting-edge radius was investigated in order to characterize the tool wear; the effect of the cutting-edge wear radius on the milling force and surface quality was found, and the formation mechanisms of the 3D surface topography and surface defects were analyzed under the wear state. Experimental results showed that the wear of the staggered PCD cutter was mainly concentrated in the cutting-edge area. With the increase in milling length, the radius of cutting edge gradually became largeer under the action of abrasive wear mechanism, and the flank wear was not obvious. With the intension of tool wear, milling force gradually increased and the machining surface quality of the CFRP deteriorated distinctly, i.e., defects such as bare fiber fracture, groove and hole appeared, and burrs were gradually generated on the workpiece surface. Finally, through a comparative analysis of cutting performance, it was found that the staggered PCD cutter possessed better performance for wear resistance and burr suppression than the straight-teeth cutter. This finding can provide theoretical and technical support for improving the machining quality of carbon fiber composite materials.Keywords
Funding Information
- International S&T Cooperation Program of China (2014DFA70400)
- National Natural Science Foundation of China (51475125)
- Natural Science Foundation of Heilongjiang Province (E2016047)
- Program for Harbin Science and Technology Innovation Talents (2015RQQXJ039)
- Distinguished Young Talents Program of Harbin University of Science and Technology
This publication has 21 references indexed in Scilit:
- Cutting Forces and 3D Surface Analysis of CFRP Milling with PCD Cutting ToolsProcedia CIRP, 2016
- Factor analysis of machining parameters of fiber-reinforced polymer composites based on finite element simulation with experimental investigationThe International Journal of Advanced Manufacturing Technology, 2015
- Development of novel tool for cutting of carbon-fiber-reinforced plastics (Positive use of abrasive wear at tool edge for reduction in cutting force)Mechanical Engineering Journal, 2015
- An investigation of workpiece temperature variation of helical milling for carbon fiber reinforced plastics (CFRP)International Journal of Machine Tools and Manufacture, 2014
- Optimal milling conditions for carbon/epoxy composite material using damage and vibration analysisThe International Journal of Advanced Manufacturing Technology, 2013
- Effect of chilled air on tool wear and workpiece quality during milling of carbon fibre-reinforced plasticWear, 2013
- Machinability and surface quality during high speed trimming of multi directional CFRPInternational Journal of Machining and Machinability of Materials, 2013
- Mechanistic force modeling for milling of unidirectional carbon fiber reinforced polymer laminatesInternational Journal of Machine Tools and Manufacture, 2012
- Occurrence and propagation of delamination during the machining of carbon fibre reinforced plastics (CFRPs) – An experimental studyComposites Science and Technology, 2011
- Factors Affecting Workpiece Surface Integrity in Slotting of CFRPProcedia Engineering, 2011