Enhancing ultra-high-performance concrete with agricultural and industrial by-products: a study on sesame oil waste ash and ceramic waste
Open Access
- 25 June 2025
- journal article
- research article
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 10 (7) , 1-26
Abstract
This study focuses on how adding ceramic waste and sesame oil waste ash (SOWA) affects the characteristics of ultra-high-performance concrete (UHPC). Different UHPC mixes were made by substituting SOWA (0–40%) for some of the cement and crushed ceramic tile waste (0–100%) for sand. The concrete's fresh and hardened properties, microstructure and durability traits were assessed. Comparing the incorporated 10% SOWA and 100% crushed ceramic tile waste to the control mix, the results demonstrated an improvement in compressive strength, splitting tensile strength, and flexural strength. By decreasing the penetration of chloride and water permeability, this combination also improved durability. A denser matrix and an enhanced interfacial transition zone with the ideal mixture were found by microstructural investigation. The study shows how ceramic waste and SOWA can be used to create sustainable UHPC with improved performance. The findings demonstrated that UHPC incorporating a 10% replacement level exhibited superior performance relative to the control mix. Specifically, the blend containing 10% SOWA and 100% crushed ceramic tile waste showed notable enhancements in mechanical properties. At 28 days, this mix achieved a compressive strength of 170.1 MPa, splitting tensile strength of 18.71 MPa, flexural strength of 27.22 MPa, and an elastic modulus of 56.86 GPa representing increases of approximately 2.5%, 4.4%, 3.8%, and 1.3%, respectively, compared to the reference specimen. Moreover, this mixture exhibited the lowest permeability values, with water permeability measured at 1.52 × 10−11 cm/s, chloride ion penetration resistance at 252 coulombs, and a sorptivity coefficient of 2.47 × 10−4 mm/s0.5, indicating improvements of around 3.5%. Microstructural analysis further revealed that the incorporation of agricultural waste contributed to a refinement of pore structure, resulting in a denser matrix. This densification is likely responsible for the enhanced durability and mechanical characteristics observed in the modified UHPC. Graphical abstractKeywords
Funding Information
- Delta University for Science and Technology
This publication has 62 references indexed in Scilit:
- Effect of air entraining and pumice on properties of ultra-high performance lightweight concreteArchives of Civil and Mechanical Engineering, 2023
- Effects of nano titanium and nano silica on high‐strength concrete properties incorporating heavyweight aggregateStructural Concrete, 2023
- Properties and durability of self‐compacting concrete incorporated with nanosilica, fly ash, and limestone powderStructural Concrete, 2023
- Effect of modified nano‐titanium and fly ash on ultra‐high‐performance concrete propertiesStructural Concrete, 2023
- A new systematic firefly algorithm for forecasting the durability of reinforced recycled aggregate concreteFrontiers of Structural and Civil Engineering, 2022
- Characteristics of sustainable high strength concrete incorporating eco-friendly materialsInnovative Infrastructure Solutions, 2021
- Optimizing metakaolin and silica-fume in rc beams with/without strengtheningInnovative Infrastructure Solutions, 2021
- Feasibility study of an off-grid biomethane mobile solution for agri-wasteApplied Energy, 2019
- Effect of processed pozzolans on residual mechanical properties and macrostructure of high‐strength concrete at elevated temperaturesStructural Concrete, 2018
- Mechanical behaviour of non-structural concrete made with recycled ceramic aggregatesCement and Concrete Composites, 2005