A study on the cyclic shear and particle breakage characteristics of the interface between steel and calcareous sand
- 21 November 2022
- journal article
- research article
- Published by Taylor & Francis in Marine Georesources & Geotechnology
- Vol. 41 (12) , 1426-1439
Abstract
Research on the mechanical properties of structure–soil interfaces is of great significance to engineering construction in the South China Sea. In this work, an interfacial cyclic shear test between steel and calcareous sand was carried out using self-developed shear equipment, and the macroscopic shear characteristics and particle breakage characteristics were analysed. The results showed that the interfacial peak shear stress under constant stiffness showed more significant weakening characteristics than under constant stress. The calcareous sand showed regular shear shrinkage and dilatancy in a single cycle and was continuously compressed with the number of cycles. The position of the shear stress–normal stress curve moved in the direction of low normal stress with the number of cycles. Under the condition of constant stiffness, the interfacial friction angle at 200kPa increased with the number of cycles, but showed the opposite rule at 1100kPa. The interface shear stiffness under constant stress first decreased and then increased with the number of cycles, while it always decreased under constant stiffness. The relative crushing value increased with the number of cycles; however, the increasing range gradually decreased, and obvious fracture was observed on the surfaces of the broken particles.Keywords
Funding Information
- the Natural Foundation of Shandong Province (ZR2020QE257)
- the Natural Foundation of Tibet Autonomous Region (XZ202001R0058G)
- the Transportation technology project of Shandong Province (2020B23)
- the Science and Technology project of Tibet Autonomous Region (XZ202001ZY0013G)
- the Science and technology planning project of Weifang High tech Zone (2021KJHM29)
This publication has 32 references indexed in Scilit:
- Evolutionary-based approaches for determining the deviatoric stress of calcareous sandsComputers & Geosciences, 2013
- Shaft Friction from Instrumented Displacement Piles in an Uncemented Calcareous SandJournal of Geotechnical and Geoenvironmental Engineering, 2012
- Engineering characteristics of the calcareous sand in Nansha Islands, South China SeaEngineering Geology, 2011
- Advancing pipe–soil interaction models in calcareous sandApplied Ocean Research, 2010
- The magic of sands — The 20th Bjerrum Lecture presented in Oslo, 25 November 2005This paper represents the written version of the 20th Bjerrum Lecture. While it has been edited for the present publication, it retains the general structure of the original lecture, which was intended for a general geotechnical audience. It deliberately points out some of the still-open questions concerning soil modelling. The Bjerrum Lecture is presented in Oslo in alternate years by the Norwegian Geotechnical Society with the support of the Bjerrum Memorial Fund (Laurits Bjerrums Minnefond).Canadian Geotechnical Journal, 2007
- Breakage mechanics—Part II: Modelling granular materialsJournal of the Mechanics and Physics of Solids, 2007
- Breakage mechanics—Part I: TheoryJournal of the Mechanics and Physics of Solids, 2007
- Monotonic Lateral Loading of Piles in Calcareous SandJournal of Geotechnical and Geoenvironmental Engineering, 2001
- Failure envelopes for caisson foundations in calcareous sedimentsApplied Ocean Research, 1998
- Compressibility And Crushing Of Granular Soil In Anisotropic Triaxial CompressionCanadian Geotechnical Journal, 1967