The Influence of Cryogenic Conditions on the Process of AA2519 Aluminum Alloy Cracking
Open Access
Abstract
This study presents the results of tests involving determining quantities used to describe fracture toughness of a heat-treated AA2519 aluminum alloy applied in, among other things, constructing American military amphibians. These quantities were determined using the J–R curve method for two temperature values, 293 K and 77 K. The low temperature was provided by putting the tested specimen into a liquid nitrogen bath and keeping it there throughout the experiment. Based on the tests results, cryogenic conditions cause an increase in the maximum experimental value of the J–JQ integral, from 66.3 to 87.3 kJ/m2 Moreover, an analysis of the fatigue fracture microstructure revealed differences between specimens tested in ambient temperature and those tested in cryogenic temperature.Keywords
Funding Information
- The National Centre for Research and Development of Poland (PBS2/A5/35/2013)
This publication has 23 references indexed in Scilit:
- Analysis of axial load and bending load effects on the fatigue lifeAIP Conference Proceedings, 2018
- Fatigue crack growth analysis in Al/Ti layered material in ambient and cryogenic conditionsProcedia Engineering, 2018
- Crack initiation and growth analysis in explosively welded AA2519–AA1050–Ti6Al4V layered material in ambient and cryogenic conditionsProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2017
- Effect of thermomechanical treatment on the microstructure, phase composition, and mechanical properties of Al–Cu–Mn–Mg–Zr alloyPhysics of Metals and Metallography, 2016
- Studies of the AA2519 Alloy Hot Rolling Process and Cladding with EN AW-1050A AlloyArchives of Metallurgy and Materials, 2016
- Fracture Toughness of Explosively Welded Al/Ti Layered Material in Cryogenic ConditionsProcedia Structural Integrity, 2016
- Microstructure Simulation of 2519 Aluminum Alloy in Multi-pass Hot Compression ProcessProcedia Engineering, 2014
- Hot deformation behavior and microstructural evolution of Ag-containing 2519 aluminum alloyMaterials & Design (1980-2015), 2010
- Effects of Ag on microstructure and mechanical properties of 2519 aluminum alloyJournal of Central South University of Technology, 2006
- Elevated temperature fracture toughness of Al-Cu-Mg-Ag sheet: Characterization and modelingMetallurgical and Materials Transactions A, 1997