Investigation on the Effects of Various Pore-Forming Agents on Bending Strength and Porosity of Al2O3 Ceramics
Open Access
- 30 September 2020
- journal article
- Published by College of Engineering - University of Kerbala in Kerbala Journal for Engineering Sciences
- No. 1,p. 1-17
Abstract
The current paper shows an economic and simple way which useful approach to produce porous ceramics (alumina) using three types of pore-forming agents (PFAs) utilizing a fugitive materials technique. Yeast material (natural active), ash of rice husk (commercial), and waste of graphite from used primary batteries have been used as (PFAs). Practical results revealed that with increasing the PFA ratio for yeast material (natural active), ash of rice husk, and waste of graphite the porosity increased from 30.2 to 63.8 %, 42.9 to 49.0%, and 37.3 to 61.1% respectively. Utilizing the three-point bending test, the evaluation of the mechanical behavior of porous ceramics (alumina) specimens was a function of the level of porosity. The characterization of mechanical behavior exhibit that the bending strength using the ash of rice husk increased at 50 wt% (92.38 ± 2.68 MPa) and 30 wt %( 93.03±4.07) due to the presence of the ceramic phases. While the bending strength of porous ceramics (alumina) using yeast material (natural active) and waste of graphite as PFAs decreased from 72.56±3.07 to 20.72±1.58 MPa and from 71.28±1.78 to 30.42±2.15 MPa respectively. Recommended application fields include the metal of molten, hot gas filters, and implantation processes.Keywords
This publication has 35 references indexed in Scilit:
- Enhanced mechanical properties and decreased thermal conductivity of porous alumina ceramics by optimizing pore structureCeramics International, 2018
- The effect of nano-copper additives on the porosity, mechanical properties, and microstructure of alumina ceramics using commercial rice husk ash as a pore formerJournal of the Australian Ceramic Society, 2017
- Mechanical characterization of micro- and nano-porous aluminaCeramics International, 2015
- Biotemplated fabrication of porous alumina ceramics with controllable pore size using bioactive yeast as pore-forming agentCeramics International, 2015
- Macroporous ceramics: Novel route using partial sintering of alumina-powder agglomerates obtained by spray-dryingCeramics International, 2014
- Green properties of dry-pressed alumina compacts fabricated using sucrose as binderCeramics International, 2014
- Fabrication and properties of porous mullite ceramics from calcined carbonaceous kaolin and α-Al2O3Ceramics International, 2010
- Effect of additive composition on microstructure and strength of porous silicon carbide ceramicsJournal of Materials Science, 2009
- Sintering behavior of porous SiC ceramicsCeramics International, 2004
- Paper pulp waste— a new source of raw material for the synthesis of a porous ceramic compositeBulletin of Materials Science, 2002