Experimental analysis of aluminium/carbon epoxy hybrid laminates under flexural load
Open Access
- 22 June 2019
- journal article
- research article
- Published by Gruppo Italiano Frattura in Fracture and Structural Integrity
- Vol. 13 (49) , 739-747
Abstract
Industry needs new materials that present very high structural characteristic, such as high strength, low weight and high damage tolerance. To obtain these characteristics a new class of materials has been introduced: Fibre Metal Laminate (FML); they consist in metal sheets alternated to composite material layers: in such manner, the good characteristics of each constituent material confer the utmost properties to the FMLs. However, the mechanical properties depend, among other factors, on the thickness and the numerousness of the layers constituting the FML, as well as the interface between metal and composite. Therefore, in this paper, the influence of the abovementioned factors on the material answer to flexural load was investigated. In particular, different kinds of laminates were produced varying the layers adhesion and the layers thickness, but maintaining unaltered the metal/composite volume ratio and the total laminate thickness. Then their structural behaviour was investigated through three-point bending test, and it was found that the flexural behaviour was affected by both the investigated factors; in fact, the maximum flexural load diminished incrementing the number of layers and inserting an adhesive layer at the metal/composite interface.Keywords
This publication has 23 references indexed in Scilit:
- The Influence of the Thickness and Areal Density on the Mechanical Properties of Carbon Fibre Reinforced Aluminium Laminates (CARAL)Transactions of the Indian Institute of Metals, 2018
- Adhesion of metallic glass and epoxy in composite-metal bondingComposites Part B: Engineering, 2018
- Galvanic Corrosion and Mechanical Behavior of Fiber Metal Laminates of Metallic Glass and Carbon Fiber CompositesAdvanced Engineering Materials, 2017
- In-process monitoring of cure degree by coplanar plate sensorsThe International Journal of Advanced Manufacturing Technology, 2016
- Preparation and properties of Fibre–Metal Laminates based on carbon fibre reinforced PMR polyimideComposites Part B: Engineering, 2015
- Applicability of AZ31B-H24 magnesium in Fibre Metal Laminates – An experimental impact researchComposites Part A: Applied Science and Manufacturing, 2012
- Experimental and Numerical Investigation of Metal Type and Thickness Effects on the Impact Resistance of Fiber Metal LaminatesApplied Composite Materials, 2011
- An experimental investigation into the progression of damage in pin-loaded fibre metal laminatesComposites Part B: Engineering, 2008
- The fracture properties of a fibre–metal laminate based on magnesium alloyComposites Part B: Engineering, 2005
- Changes in the distribution of microtubules and intermediate filaments in mammalian Sertoli cells during spermatogenesisThe Anatomical Record, 1988