Aluminum Heat Sink Assisted Air-Cooling Thermal Management System for High Current Applications in Electric Vehicles
Authors:
- Hamidreza BehiHamidreza Behi
- Danial KarimiDanial Karimi
- Joris JaguemontJJJoris Jaguemont
- Foad. H. GandomanFoad. H. Gandoman
- Sahar KhaleghiSKSahar Khaleghi
- Joeri Van MierloJMJoeri Van Mierlo
- Maitane BerecibarMBMaitane Berecibar
- 18 November 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Abstract
Lithium-ion (Li-ion) batteries are preferred energy storage systems for vehicular applications due to the high capacity, long life, and power density. This paper offers the concept of a hybrid thermal management system (TMS), including a prismatic cell embedded fin heat sink (CHS) for high current applications. The experimental tests and numerical simulations are done to investigate the thermal characteristic of the utilized battery and CHS in natural and forced convection in 8C discharging rate (184 A). Results indicate that the maximum cell temperature in natural convection (NC) reaches 56 °C. Moreover, the temperature of the CHS in natural and forced convection reaches 51.5 °C and 31.1 °C. For further investigation, the optimization, including three cases, is done for the geometry of the forced convection cooling box. Results indicate that the maximum temperature of the CHS compared with NC reduced by 39.6%, 40.9%, and 38.4% for cases A, B, and C, respectively. In addition, there is an improvement of 6%, 28%, and 36% in the cell temperature uniformity for cases A, B, and C, respectively. It is also found that the inlet velocity of 3 m/s preserves the CHS in a safe temperature zone, which decreases the fan power consumption by 50%.Keywords
This publication has 26 references indexed in Scilit:
- Three dimensional thermal model development and validation for lithium-ion capacitor module including air-cooling systemApplied Thermal Engineering, 2019
- Evaluation of a novel solar driven sorption cooling/heating system integrated with PCM storage compartmentEnergy, 2018
- Design of the cell spacings of battery pack in parallel air-cooled battery thermal management systemInternational Journal of Heat and Mass Transfer, 2018
- Investigation of PCM-assisted heat pipe for electronic coolingApplied Thermal Engineering, 2017
- Experimental investigation on the thermal performance of heat pipe-assisted phase change material based battery thermal management systemEnergy Conversion and Management, 2017
- Computational fluid dynamic and thermal analysis of Lithium-ion battery pack with air coolingApplied Energy, 2016
- Performance assessment and optimization of a heat pipe thermal management system for fast charging lithium ion battery packsInternational Journal of Heat and Mass Transfer, 2016
- Numerical analyses on optimizing a heat pipe thermal management system for lithium-ion batteries during fast chargingApplied Thermal Engineering, 2015
- Characterization and Modeling of a Hybrid-Electric-Vehicle Lithium-Ion Battery Pack at Low TemperaturesIEEE Transactions on Vehicular Technology, 2015
- Cooling performance of nanofluids in a small diameter tubeExperimental Thermal and Fluid Science, 2013