Preparation and Fuel Cell Performance of Catalyst Layers Using Sulfonated Polyimide Ionomers
- 17 January 2012
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 4 (2) , 730-737
Abstract
Sulfonated polyimide (SPI-8) ionomers were used as binders in the catalyst layers, and their fuel cell performance was evaluated. SPI-8 ionomers functioned well in the anode with only minor overpotential even at low humidity (50% relative humidity (RH)). In contrast, the cathode performance was significantly dependent on the content and molecular weight of the ionomers and humidity of the supplied gases. Higher molecular weight of the ionomer caused larger potential drop at high current density at 80 and 100% RH since oxygen supply and/or water discharge became insufficient due to higher water uptake (swelling) of the ionomer. Similar results were obtained at higher ionomer content, because of the increase of thickness in the catalyst layer. The mass transport was improved with decreasing humidity, however, proton conductivity became lower. While the maximum values of j@0.70 V for all membrane electrode assemblies (MEAs) were ca. 0.35 A/cm2, each electrode could have the different appropriate operating conditions. The results suggest that the parameters such as oxygen supply, proton conductivity, and water uptake and discharge need to be carefully optimized in the catalyst layers for achieving reasonable cathode performance with hydrocarbon ionomers.Keywords
This publication has 32 references indexed in Scilit:
- Synthesis and Properties of Sulfonated Block Copolymers Having Fluorenyl Groups for Fuel-Cell ApplicationsACS Applied Materials & Interfaces, 2009
- EPR spectroscopic investigation of radical-induced degradation of partially fluorinated aromatic model compounds for fuel cell membranesPhysical Chemistry Chemical Physics, 2009
- Synthesis and Properties of Polyimide Ionomers Containing 1H-1,2,4-Triazole GroupsMacromolecules, 2008
- Aliphatic/Aromatic Polyimide Ionomers as a Proton Conductive Membrane for Fuel Cell ApplicationsJournal of the American Chemical Society, 2006
- Water Stability of Sulfonated Polyimide MembranesMacromolecules, 2006
- Ionomeric Poly(phenylene) Prepared by Diels−Alder Polymerization: Synthesis and Physical Properties of a Novel PolyelectrolyteMacromolecules, 2005
- Alternative Polymer Systems for Proton Exchange Membranes (PEMs)Chemical Reviews, 2004
- Direct polymerization of sulfonated poly(arylene ether sulfone) random (statistical) copolymers: candidates for new proton exchange membranesJournal of Membrane Science, 2002
- Recent advances in the functionalisation of polybenzimidazole and polyetherketone for fuel cell applicationsJournal of Membrane Science, 2001
- Proton-conducting polymer electrolyte membranes based on hydrocarbon polymersProgress in Polymer Science, 2000