Evaluation of the start-up of hydraulic conditions of a fluidised bed system
- 15 June 2021
- journal article
- research article
- Published by Taylor & Francis in Environmental Technology
- Vol. 43 (26) , 4029-4041
Abstract
The development of this research was based on the analysis of an anaerobic fluidised bed reactor from the assembly of its components to the sealing of the system and further fluidisation. A hydrometer and a Venturi were used to identify the best means of measuring the flow rate. Results produced by both devices were similar, however, the latter was less effective due to the low flow rates necessary to operate the system. The hydrometer was the most adequate device for flow rate measurements in the range between 0.1 and 1.0 m³/h, whereas the Venturi proved to be an adequate device for the flow in the range between 0.3 and 0.7 m³/h. Sand with grain sizes varying from 357 to 1000 µm was used as support material. It was not observed statistically significant differences between the minimum fluidisation velocities related to the amount of supported material of 20% and 40% (VSM/Vusable) added to the reactor. Forty percent of the usable volume occupied with sand is adequate to reach fluidisation, instead of only the expansion of the bed. The fluidisation velocities for the sand grain size of 357 µm were 8.4 m/h ± 0.25 for 20%, and 8.6 m/h ± 0.30 for 40%, whereas for the 505 µm they were, respectively for 20% and 40%, 9.2 m/h ±0.70 and 10.1 m/h ± 0.37. The hydraulic tests allow to stress that sand grain sizes varying from 357 to 505 µm are recommended to be used in a system with similar characteristics. GRAPHICAL ABSTRACTKeywords
Funding Information
- CAPES (Scholarship)
This publication has 56 references indexed in Scilit:
- Effects of influent DO/COD ratio on the performance of an anaerobic fluidized bed reactor fed low-strength synthetic wastewaterBioresource Technology, 2011
- Anaerobic degradation of linear alkylbenzene sulfonate (LAS) in fluidized bed reactor by microbial consortia in different support materialsBioresource Technology, 2010
- Potentials of anaerobic treatment for catalytically oxidized olive mill wastewater (OMW)Bioresource Technology, 2009
- Brewery wastewater treatment using anaerobic inverse fluidized bed reactorsBioresource Technology, 2008
- Influence of hydrodynamic conditions on the start-up of methanogenic inverse turbulent bed reactorsWater Research, 2007
- Autotrophic growth of anaerobic ammonium-oxidizing micro-organisms in a fluidized bed reactorMicrobiology, 1996
- What is turbulent fluidization?Powder Technology, 1996
- Review on the application of anaerobic fluidized bed reactors in waste-water treatmentThe Chemical Engineering Journal, 1989
- Packed‐ and fluidized‐bed biofilm reactor performance for anaerobic wastewater treatmentBiotechnology and Bioengineering, 1988
- Anaerobic fluidized bed whey treatmentBiotechnology and Bioengineering, 1982