Stress and Failure Prediction for the Drying, Tempering, and Cooling of Extruded Durum Semolina
Authors:
- 1 January 1993
- journal article
- research article
- Published by Taylor & Francis in Drying Technology
- Vol. 11 (7) , 1809-1836
Abstract
This work presents a method to predict the stress and breakage that is caused by the drying of hygros-copic materials. Stresses were predicted for a viscoclasic cylinder with the properties of extruded durum semolina, or pasta noodles. The stresses were calculated as functions of the transient moisture and tem-perature gradients in the material which were predicted for the combined processes of drying, tempering,and cooling. The time and radial position of failure were predicted based on failure data for extruded semolina. Isotherm data for extruded durum semolina were obtained for temperatures from 40 to 60°C and for relative humidities from 75 to 95%. The results were fit with a modified form of Henderson's equation.Thermal conductivities were measured for temperatures from 30 to 50°C and a moisture range of 12 to 27% (dry basis). A drying model based on the principles of irreversible thermodynamics; (Fortes, 1978; Fortes and Okos, 1981a, 1981b) was used to successfully predict drying curves for a range of experimental conditions. Transient moisture and temperature profiles were calculated numerically, and a receding evapora-tion front was predicted to exist. Drying was predicted to be a coupled liquid, vapor, and heat transport phenomena. The drying data were used in a stress analysis of a Maxwell viscoelastic cylinder to predict trends in stress development under various contiitions of combined drying, tempering, and cooling. High temperature-high humidity drying, HTHH, (lOO°C, 65% RH) was compared with low temperature-low humidity drying, LTLH, (53°C, 13% RH). The HTHH drying offered definite advantages in terms of reduced product breakage susceptibility. The reasons for those advantages were increased failure strength and a decreased moisture gradient at the end of drying. In a five-stage drying process, the cooling stage was shown to have a significant impact on the predicted levels of stress and on the strength of the extruded material. Analysis of the model suggested that gradual temperature and humidity transitions from stage to stage in multistage processes were important to product quality.Keywords
This publication has 17 references indexed in Scilit:
- High Temperature Drying: Effect on Spaghetti PropertiesJournal of Food Science, 1981
- Improved Line Heat Source Thermal Conductivity ProbeJournal of Food Science, 1981
- Heat and mass transfer analysis of intra-kernel wheat drying and rewettingJournal of Agricultural Engineering Research, 1981
- Heat and mass transfer in hygroscopic capillary extruded productsAIChE Journal, 1981
- A Non-Equilibrium Thermodynamics Approach to Transport Phenomena in Capillary Porous MediaTransactions of the ASAE, 1981
- Viscoelastic Behavior of Soybeans Due to Temperature and Moisture ContentTransactions of the ASAE, 1979
- Drying of hygroscopic capillary porous solids —A theoretical approachInternational Journal of Heat and Mass Transfer, 1973
- Theoretical Analysis of Failure in a Viscoelastic Slab Subjected to Temperature and Moisture GradientsTransactions of the ASAE, 1972
- Thermal Expansion and Tensile Properties of Corn Kernels and Their Relationship to Cracking During DryingTransactions of the ASAE, 1966
- Simultaneous transfer of heat and moisture in porous mediaEOS, Transactions American Geophysical Union, 1958