Numerical Investigation of GDI Injector Nozzle Geometry on Spray Characteristics
Authors:
- 1 September 2015
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The large eddy simulation (LES) with Volume of Fluid (VOF) interface tracking method in Ansys-FLUENT has been used to study the effects of nozzle hole geometrical parameters on gasoline direct injection (GDI) fuel injectors, namely the effect of inner hole length/diameter (L/D) ratio and counter-bore diameters on near field spray characteristics. Using iso-octane as a model fuel at the fuel injection pressure of 200 bar, the results showed that the L/D ratio variation of the inner hole has a more significant influence on the spray characteristics than the counter-bore diameter variation. Reducing the L/D ratio effectively increases the mass flow rate, velocity, spray angle and reduces the droplet size and breakup length. The increased spray angle results in wall impingements inside the counter-bore cavity, particularly for L/D=1 which can potentially lead to increased deposit accumulation inside fuel injectors. The influences of the counter-bore diameter become more obvious with decreased L/D ratio. For the lower L/D ratio, the sprays with large included angles are more vulnerable to the air entrained into the counter-bore cavity and the recirculation flow inside it. Increasing the counter-bore diameter has an overall adverse effect on the spray characteristics as the spray exits the counter-bore. Flow rates and spray angles decrease and droplet sizes are increased with increased counter-bore diameters for any given L/D ratio. The positive recirculation inside the small diameter counter-bores improves the mass flow rate from the inner hole. Inside the counter-bore cavity and further downstream from it, large interconnected ligaments are present which undergo deformation and secondary breakup.Keywords
This publication has 22 references indexed in Scilit:
- Effect of nozzle geometrical and dynamic factors on cavitating and turbulent flow in a diesel multi-hole injector nozzleInternational Journal of Thermal Sciences, 2013
- Study of the influence of the inlet boundary conditions in a LES simulation of internal flow in a diesel injectorMathematical and Computer Modelling, 2013
- Computational study of the cavitation phenomenon and its interaction with the turbulence developed in diesel injector nozzles by Large Eddy Simulation (LES)Mathematical and Computer Modelling, 2013
- A contribution to the understanding of cavitation effects in Diesel injector nozzles through a combined experimental and computational investigationComputers & Fluids, 2012
- Numerical investigations in Rayleigh breakup of round liquid jets with VOF methodsComputers & Fluids, 2011
- Numerical simulation of wall roughness effects in cavitating flowInternational Journal of Heat and Fluid Flow, 2011
- Numerical simulation and extended validation of two-phase compressible flow in diesel injector nozzlesProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2011
- Validation of a code for modeling cavitation phenomena in Diesel injector nozzlesMathematical and Computer Modelling, 2010
- Cavitation, primary break-up and flash boiling of gasoline, iso-octane and n-pentane with a real-size optical direct-injection nozzleFuel, 2010
- Simulation of primary atomization with an octree adaptive mesh refinement and VOF methodInternational Journal of Multiphase Flow, 2009