Ionic liquid-enhanced solid state electrolyte interface (SEI) for lithium–sulfur batteries
- 16 May 2013
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 1 (29) , 8464-8470
Abstract
Li–S batteries are a complicated system with many challenges existing before their final market penetration. While most of the reported work for Li–S batteries is focused on the cathode design, we demonstrate in this work that the anode consumption accelerated by corrosive polysulfide solution also critically determines the Li–S cell performance. To validate this hypothesis, ionic liquid (IL) N-methyl-N-butylpyrrolidinium bis(trifluoromethylsulfonyl)imide (Py14TFSI) has been employed to modify the properties of the SEI layer formed on the Li metal surface in Li–S batteries. It is found that the IL-enhanced passivation film on the lithium anode surface exhibits very different morphology and chemical composition, effectively protecting lithium metal from continuous attack by soluble polysulfides. Therefore, both the cell impedance and the irreversible consumption of polysulfides on lithium metal are reduced. As a result, the Coulombic efficiency and the cycling stability of Li–S batteries have been greatly improved. After 120 cycles, the Li–S battery cycled in the electrolyte containing 75% IL demonstrates a high capacity retention of 94.3% at 0.1 C rate. These results reveal one of the main failure mechanisms in Li–S batteries and shine the light on new approaches to improve the reversible capacity and cyclability of Li–S batteries. This work provides important clues for the understanding and thus the improvement of Li–S battery systems through a different point of view.Keywords
This publication has 27 references indexed in Scilit:
- Role of LiNO3 in rechargeable lithium/sulfur batteryElectrochimica Acta, 2012
- A Soft Approach to Encapsulate Sulfur: Polyaniline Nanotubes for Lithium‐Sulfur Batteries with Long Cycle LifeAdvanced Materials, 2012
- The effects of N-methyl-N-butylpyrrolidinium bis(trifluoromethylsulfonyl)imide–based electrolyte on the electrochemical performance of high capacity cathode material Li[Li0.2Mn0.54Ni0.13Co0.13]O2Electrochimica Acta, 2012
- Ordered mesoporous carbon/sulfur nanocomposite of high performances as cathode for lithium–sulfur batteryElectrochimica Acta, 2011
- Sulfur–mesoporous carbon composites in conjunction with a novel ionic liquid electrolyte for lithium rechargeable batteriesCarbon, 2008
- Improved dischargeability and reversibility of sulfur cathode in a novel ionic liquid electrolyteElectrochemistry Communications, 2006
- Effects of imidazolium salts on discharge performance of rechargeable lithium–sulfur cells containing organic solvent electrolytesJournal of Power Sources, 2005
- The Zwitterion Effect in Ionic Liquids: Towards Practical Rechargeable Lithium‐Metal BatteriesAdvanced Materials, 2005
- Electrodeposition of Metallic Lithium on a Tungsten Electrode in 1-Butyl-1-methylpyrrolidinium Bis(trifluoromethanesulfone)imide Room-temperature Molten SaltElectrochemistry, 2003
- Correlation between surface chemistry, morphology, cycling efficiency and interfacial properties of Li electrodes in solutions containing different Li saltsElectrochimica Acta, 1994