Characterization of porous Pt films deposited via sputtering
Authors:
- Ikwhang ChangICIkwhang Chang
- Seunghee WooSWSeunghee Woo
- Min Hwan LeeMLMin Hwan Lee
- Joon Hyung ShimJSJoon Hyung Shim
- Yuanzhe PiaoYPYuanzhe Piao
- Suk Won ChaSCSuk Won Cha
- 1 October 2013
- journal article
- Published by Elsevier in Applied Surface Science
- Vol. 282, 463-466
Abstract
No abstract availableKeywords
Funding Information
- National Research Foundation of Korea
- Ministry of Education, Science and Technology (2011-0029576, 2011-0031569)
This publication has 22 references indexed in Scilit:
- Fabrication of low-temperature solid oxide fuel cells with a nanothin protective layer by atomic layer depositionDiscover Nano, 2013
- Do not forget the electrochemical characteristics of the membrane electrode assembly when designing a Proton Exchange Membrane Fuel Cell stackElectrochimica Acta, 2011
- Operational condition analysis for vapor-fed direct methanol fuel cellsJournal of Power Sources, 2009
- Micro Solid Oxide Fuel Cells on Glass Ceramic SubstratesAdvanced Functional Materials, 2008
- High utilization of Pt nanocatalysts fabricated using a high-pressure sputtering techniqueJournal of Power Sources, 2008
- Biosensor Based on Self‐Assembling Glucose Oxidase and Dendrimer‐Encapsulated Pt Nanoparticles on Carbon Nanotubes for Glucose DetectionElectroanalysis, 2007
- Cyclic Voltammetry Study of Ice Formation in the PEFC Catalyst Layer during Cold StartJournal of the Electrochemical Society, 2007
- Sputter-deposited ultra-low catalyst loadings for PEM fuel cellsJournal of Power Sources, 2005
- Dependence of film morphology on deposition rate in ITO/TPD/Alq3/Al organic luminescent diodesSolid-State Electronics, 2004
- A sharp peak in the performance of sputtered platinum fuel cells at ultra-low platinum loadingJournal of Power Sources, 2002