A critical review addressing drilling-induced damage of CFRP composites
Authors:
- Jinyang XuJinyang Xu
- Youkang YinYYYoukang Yin
- J. Paulo DavimJ. Paulo Davim
- Linfeng LiLLLinfeng Li
- Min JiMJMin Ji
- Norbert GeierNGNorbert Geier
- Ming ChenMCMing Chen
Top Cited Papers
- 20 April 2022
- journal article
- review article
- Published by Elsevier in Composite Structures
- Vol. 294
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China
This publication has 195 references indexed in Scilit:
- Evaluation of drilling parameters on thrust force in drilling carbon fiber reinforced plastic (CFRP) composite laminates using compound core-special drillsInternational Journal of Machine Tools and Manufacture, 2011
- Drilling tool geometry evaluation for reinforced composite laminatesComposite Structures, 2010
- Cutting edge rounding: An innovative tool wear criterion in drilling CFRP composite laminatesInternational Journal of Machine Tools and Manufacture, 2009
- Drill geometry and operating effects when cutting small diameter holes in CFRPInternational Journal of Machine Tools and Manufacture, 2009
- Drilling of carbon composites using a one shot drill bit. Part I: Five stage representation of drilling and factors affecting maximum force and torqueInternational Journal of Machine Tools and Manufacture, 2006
- Taguchi analysis of delamination associated with various drill bits in drilling of composite materialInternational Journal of Machine Tools and Manufacture, 2004
- Delamination in drilling GFR-thermoset compositesComposite Structures, 2004
- The effect of chisel length and associated pilot hole on delamination when drilling composite materialsInternational Journal of Machine Tools and Manufacture, 2003
- An experimental investigation into the orthogonal cutting of unidirectional fibre reinforced plasticsInternational Journal of Machine Tools and Manufacture, 2003
- Orthogonal cutting mechanisms of graphite/epoxy composite. Part I: unidirectional laminateInternational Journal of Machine Tools and Manufacture, 1995