Scale Effect of Filling on Overburden Migration in Local Filling Stope of Longwall Face in Steeply Dipping Coal Seam
Open Access
Abstract
The gangue filling mining method is used to reduce the occurrence of dynamic disasters on the roof of a steeply dipping coal seam (SDCS) effectively and improve the stability of the overburden structure. To comprehensively study the movement law of the overburden under different filling quantities, the 3221 working face of the Lvshuidong coal mine was taken as the research site. The vertical displacement, vertical stress, and plastic zone of the overburden under different filling quantities were analyzed by using FLAC3D numerical simulation and physical similarity simulations. The results show that the maximum stress in the stress concentration zone decreased with the increase of filling size. The vertical stress range of the overburden and floor in the filling zone increased significantly. The affected zones of the vertical displacement of the roof and floor and the vertical displacement of the overburden were reduced to varying degrees. The overall plastic zone was shrinking. The movement of overburden was well-controlled as the proportion of the fillings increased. The results of this study can provide an important reference for the stability control of the roof of SDCS filling mining.Keywords
Funding Information
- National Natural Science Foundation of China (51974226, 52174127)
- the Research Fund of Shaanxi Key Laboratory of Coal Mine Water Disaster Prevention and Control Technology (2020SKMS02)
- the Research Fund of Henan Key Laboratory for Green and Efficient Mining & Comprehensive Utilization of Mineral Resources (KCF202001)
This publication has 21 references indexed in Scilit:
- Highwall mining of thick, steeply dipping coal–a case study in geotechnical design and recovery optimizationInternational Journal of Mining Science and Technology, 2019
- Migration Law of the Roof of a Composited Backfilling Longwall Face in a Steeply Dipping Coal SeamMinerals, 2019
- Stereological correction of perimeter based estimates of exposed grain surface areaMinerals Engineering, 2018
- Mill tailings based composites as paste backfill in mines of U-bearing dolomitic limestone oreJournal of Rock Mechanics and Geotechnical Engineering, 2018
- Valorization of mining waste and tailings through paste backfilling solution, Imiter operation, MoroccoInternational Journal of Mining Science and Technology, 2016
- Post-wrinkling analysis of a torsionally sheared annular thin film by using a compound series methodInternational Journal of Mechanical Sciences, 2016
- Influence of backfill on coal pillar strength and floor bearing capacity in weak floor conditions in the Illinois BasinInternational Journal of Rock Mechanics and Mining Sciences, 2015
- An integrated method to calculate the spatial distribution of overburden strata failure in longwall mines by coupling GIS and FLAC3DInternational Journal of Mining Science and Technology, 2015
- Effects of curing and stress conditions on hydromechanical, geotechnical and geochemical properties of cemented paste backfillEngineering Geology, 2014
- Improving Short- and Long-term Stability of Underground Gypsum Mine Using Partial and Total BackfillRock Mechanics and Rock Engineering, 2009