Optimization design and drag reduction characteristics of bionic borehole heat exchanger
Authors:
Open Access
- 28 September 2022
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Abstract
As a renewable energy source, geothermal energy has drawn attention because it is clean, low-carbon, resource-rich, stable, and sustainable supply. In the mining and operation of a geothermal energy system, there is a certain amount of fluid resistance in the borehole heat exchanger where the fluid flows. As the resistance in the conventional borehole heat exchanger (CBHE) accumulates with the length increase, the pumping power increases, resulting in energy loss and affecting the operation of the entire geothermal system. A bionic borehole heat exchanger (BBHE) is designed using a circular groove as a bionic unit based on the bionic non-smooth surface hypothesis. Its structural characteristics are the circular groove’s depth, width, and slot pitch. Where the fluid faces the least resistance, minimization of the pressure drop was the optimization goal. Based on the outcomes of a CFD numerical simulation and genetic algorithm optimization study. These are the BBHE’s ideal structural parameters: diameter is 60 mm, 66 mm for the groove width, 418 mm for the slot pitch, and 80 mm for the groove depth. Compared to the CBHE, under identical numerical simulation settings, the fluid resistance reduction rate of BBHE can reach 13%. Increasing fluid velocity in the BBHE can increase the temperature transmission rate. The study’s findings can serve as a reliable source of scientific information for the use and management of geothermal energy.Keywords
This publication has 42 references indexed in Scilit:
- Nanofluids as the circuit fluids of the geothermal borehole heat exchangersInternational Communications in Heat and Mass Transfer, 2017
- Numerical investigation of a novel tube design for the geothermal borehole heat exchangerApplied Thermal Engineering, 2015
- Research on the Flow Characteristics of Sudden-Reduction Oil TubeThe Open Mechanical Engineering Journal, 2015
- Flow of yield-stress liquids through an axisymmetric abrupt expansion-contractionJournal of Non-Newtonian Fluid Mechanics, 2013
- Flow of elasto-viscoplastic liquids through a planar expansion–contractionRheologica Acta, 2013
- Shark-skin surfaces for fluid-drag reduction in turbulent flow: a reviewPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2010
- Two-Phase Flow Across Small Sudden Expansions and ContractionsHeat Transfer Engineering, 2010
- Oscillating flow in channels with a sudden change in cross sectionComputers & Fluids, 1994
- Near-wall structure of a turbulent boundary layer with ribletsJournal of Fluid Mechanics, 1989
- A combined visualization-anemometry study of the turbulent drag reducing mechanisms of triangular micro-groove surface modifications1985