Comparison of Microstructure and Mechanical Properties of Ultra-Narrow Gap-Welded and Submerged Arc-Welded Q355E HSLA Steel
Open Access
Abstract
Reasonable welding methods are of great significance for optimizing the microstructure and ensuring the mechanical properties of welded joints. In this study, ultra-narrow gap welding (UNGW) and submerged arc welding (SAW) were employed to weld Q355E high-strength low-alloy (HSLA) steel thick plates, and the microstructure and mechanical properties of the welded joints were systematically characterized. The UNGW welded joint exhibits superior comprehensive mechanical properties: a room-temperature tensile strength of 664 MPa with 43.1% elongation at fracture, along with higher microhardness and enhanced impact performance at −40 °C, all of which significantly outperform SAW welded joints. This advantage primarily stems from the faster cooling rate during UNGW, which promotes the formation of beneficial acicular ferrite in the joint microstructure. This study provides theoretical support and technical guidance for welding HSLA steel thick plates.Keywords
This publication has 33 references indexed in Scilit:
- The microstructure evolution and influence factors of acicular ferrite in low alloy steelsComputational Materials Science, 2022
- Laser-arc hybrid welding of thick HSLA steelJournal of Materials Processing Technology, 2018
- Effect of solution treatment on microstructure and cryogenic toughness of 316LN austenite stainless steel weld metal welded by NG-MAG arc weldingFusion Engineering and Design, 2017
- Groove sidewall penetration modeling for rotating arc narrow gap MAG weldingThe International Journal of Advanced Manufacturing Technology, 2014
- Development of ferrite/bainite bands and study of bainite transformation retardation in HSLA steel during continuous coolingMetals and Materials International, 2014
- Synergistic alloying effect on microstructural evolution and mechanical properties of Cu precipitation-strengthened ferritic alloysActa Materialia, 2013
- Microstructure characterization of Cu-rich nanoprecipitates in a Fe–2.5 Cu–1.5 Mn–4.0 Ni–1.0 Al multicomponent ferritic alloyActa Materialia, 2013
- New insights into intragranular ferrite in a low-carbon low-alloy steelActa Materialia, 2009
- Al–Al3Ti nanocomposites produced in situ by friction stir processingActa Materialia, 2006
- Cleavage initiation in the intercritically reheated coarse-grained heat-affected zone: Part I. Fractographic evidenceMetallurgical and Materials Transactions A, 1994