Modification of Al alloy nanopowder with Nb nanopowder on its thermal and tribological properties with SPS for power conductors
- 18 October 2019
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (11) , 116592
Abstract
Al 1000 alloy has high purity and good electrical conductivity required for high power transmission conductors but lacks adequate thermal and tribological properties necessary for optimal performance and durability. To augment these properties, Nb nanopowder was incorporated into Al base metal and consolidated with spark plasma sintering (SPS). The SPS was conducted with pre-optimized processing parameters of 630 °C temperature, 30 MPa pressure, 10 min holding time and 200 °C min−1 heating rate. The sintering was conducted in a vacuum with graphite die of 20 mm in diameter. Thereafter, the sintered samples were metallographically prepared and subjected to thermal and tribological testing. A laser flash analysis (LFA) and thermogravimetric analysis (TGA) were used in the thermal test while ball-on-disc tribometer was used in the tribology test. Results obtained showed that Al-4Nb had the highest thermal conductivity of 115. 95 ± 6.9 Wm-1K−1 which represented 42% improvement. The same sample had best tribology characteristics with 45% improvement in coefficient of friction (COF), 20% improvement in both wear volume and wear rate. So, it follows that Al-Nb composite is a better replacement for monolithic Al 1000 alloy in power transmission conductors with a potential property of low sag and high wear resistance during operation.Keywords
Funding Information
- Tshwane University of Technology (2019 Internal bursary)
This publication has 20 references indexed in Scilit:
- Influence of microstructure and heat treatment on thermal conductivity of rheocast and liquid die cast Al-6Si-2Cu-Zn alloyInternational Journal of Cast Metals Research, 2016
- Experimental Investigations on Thermal Analysis and Thermal Characterization of Al 6061-Sic-Gr Hybrid Metal Matrix CompositesInternational Journal of Material Sciences, 2015
- Low temperature thermal conductivity of aluminum alloy 5056Cryogenics, 2014
- Influence of spark plasma sintering parameters on densification and mechanical properties of boron carbideInternational Journal of Refractory Metals and Hard Materials, 2014
- Microstructure and Properties of Spark Plasma Sintered Carbon Nanotube Reinforced Aluminum Matrix CompositesAdvanced Engineering Materials, 2011
- Room temperature dry and lubricant wear behaviors of Al2O3f/SiCp/Al hybrid metal matrix compositesWear, 2010
- Comparison on abrasive wear of SiCrFe, CrFeC and Al2O3 reinforced Al2024 MMCsTribology International, 2007
- On the SEM features of glass–polyester composite system subjected to dry sliding wearWear, 2006
- A Composite Core Conductor for Low Sag at High TemperaturesIEEE Transactions on Power Delivery, 2005
- Behavior of oxide film at the interface between particles in sintered Al powders by pulse electric-current sinteringMetallurgical and Materials Transactions A, 2003