Fabrication of Low-Density Shock-Propagation Targets Using Two-Photon Polymerization
Authors:
- 29 December 2017
- journal article
- conference paper
- Published by Taylor & Francis in Fusion Science and Technology
- Vol. 73 (2) , 153-165
Abstract
Low-density foam targets were fabricated by direct laser writing using two-photon polymerization (2PP). The targets were used in high-energy-density shock-propagation experiments carried out on the NIKE laser system at the Naval Research Laboratory (NRL). The basic target comprised a rectilinear foam rod with a log-pile-like microstructure with overall dimensions of 2000 × 250 × 315 μm3 and a nominal density of ~100 mg/cm3. The foam block is topped with a 15-μm-thick, full-density ablation layer that is integrated into the 2PP printing process. The main challenge in fabricating the foam targets comes in maintaining dimensional and structural stability during 2PP postprocessing particularly during development, drying, and release from the substrate. Twelve 2PP foam rods were characterized and then built into targets. The characterization data show shrinkage of ~5% to 15% in overall dimensions attributed mainly to shrinkage of the acrylic resin (IP-Dip). Continuing development shows that use of the more stable IP-S commercial resin leads to significantly improved foam structure stability, reduced shrinkage, and a lower number of inherently weak stitching boundaries. The 12 targets provided to NRL have been shot; an example of the type of data obtained is presented.Keywords
This publication has 18 references indexed in Scilit:
- Performance comparison of acrylic and thiol-acrylic resins in two-photon polymerizationOptics Express, 2016
- Resilient 3D hierarchical architected metamaterialsProceedings of the National Academy of Sciences, 2015
- Two-photon polymerization: investigation of chemical and mechanical properties of resins using Raman microspectroscopyOptics Letters, 2014
- Tailored 3D Mechanical Metamaterials Made by Dip‐in Direct‐Laser‐Writing Optical LithographyAdvanced Materials, 2012
- Stability of a Shock-Decelerated Ablation FrontPhysical Review Letters, 2009
- Multiphoton FabricationAngewandte Chemie International Edition, 2007
- The properties of foams and latticesPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2005
- Development of Divinylbenzene Foam Shells for Use as Inertial Fusion Energy Reactor TargetsFusion Science and Technology, 2003
- Direct observation of mass oscillations due to ablative Richtmyer–Meshkov instability and feedout in planar plastic targetsPhysics of Plasmas, 2002
- Surface Tension of Alcohol Water + Water from 20 to 50 .degree.CJournal of Chemical & Engineering Data, 1995