Monitoring the efficiency of cooling air at the inlet of gas engine in integrated energy system
Open Access
- 1 January 2022
- journal article
- research article
- Published by National Library of Serbia in Thermal Science
- Vol. 26 (1 Part A) , 185-194
Abstract
The fuel efficiency of gas engines is effected by the temperature of intake air at the suction of turbocharger. The data on dependence of fuel consumption and engine electric power on the intake air temperature were monitored for Jenbacher gas engine JMS 420 GS-N.LC to evaluate its influence. A waste heat of engine is rejected for heating water to the temperature of about 90??. The heat received is used in absorption lithium-bromide chiller to produce a cold in the form of chilled water. A cooling capacity of absorption chiller firstly is spent for technological needs and then for feeding the central air conditioner for cooling the ambient air incoming the engine room, from where the air is sucked by the engine turbocharger. The monitoring data revealed the reserves to enhance the efficiency of traditional cooling system of intake air by absorption chiller through deeper cooling. This concept can be realized in two ways: by addition cooling a chilled water from absorption chiller to about 5-7?? for feeding engine intake air cooler or by two-stage cooling with precooling ambient air by chilled water from adsorption chiller, in the first stage and subsequent deep cooling air to the temperatures 7-10?? in the second stage of intake air cooler by using a refrigerant as a coolant. In both cases the ejector chiller could be applied as the most simple in design.Keywords
This publication has 32 references indexed in Scilit:
- Influence of initial bed temperature on bed performance of an adsorption refrigeration systemThermal Science, 2018
- Experimental investigation of a two-phase ejector cycle suitable for use with low-pressure refrigerants R134a and R1234yfInternational Journal of Refrigeration, 2014
- Adsorber efficiency in adsorbtion refrigerationRenewable and Sustainable Energy Reviews, 2013
- Thermal modeling and operating tests for a gas-engine driven heat pump working as a water heater in winterEnergy and Buildings, 2013
- Low-grade waste heat recovery for simultaneous chilled and hot water generationApplied Thermal Engineering, 2012
- An evaluation of empirically-based models for predicting energy performance of vapor-compression water chillersApplied Energy, 2010
- A novel approach to degree-hour calculation: Indoor and outdoor reference temperature based degree-hour calculationEnergy, 2010
- Multi-objective optimization of a trigeneration plantEnergy Policy, 2010
- Cost optimization of the design of CHCP (combined heat, cooling and power) systems under legal constraintsEnergy, 2010
- On reducing the size of liquid separators for injector circulation plate freezersInternational Journal of Refrigeration, 1985