Characteristics of In-Substituted CZTS Thin Film and Bifacial Solar Cell
- 6 November 2014
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 6 (23) , 21118-21130
Abstract
Implementing bifacial photovoltaic devices based on transparent conducting oxides (TCO) as the front and back contacts is highly appealing to improve the efficiency of kesterite solar cells. The p-type In substituted Cu2ZnSnS4 (CZTIS) thin-film solar cell absorber has been fabricated on ITO glass by sulfurizing coelectroplated Cu–Zn–Sn–S precursors in H2S (5 vol %) atmosphere at 520 °C for 30 min. Experimental proof, including X-ray diffraction, Raman spectroscopy, UV–vis–NIR transmission/reflection spectra, PL spectra, and electron microscopies, is presented for the interfacial reaction between the ITO back contact and CZTS absorber. This aggressive reaction due to thermal processing contributes to substitutional diffusion of In into CZTS, formation of secondary phases and electrically conductive degradation of ITO back contact. The structural, lattice vibrational, optical absorption, and defective properties of the CZTIS alloy absorber layer have been analyzed and discussed. The new dopant In is desirably capable of improving the open circuit voltage deficit of kesterite device. However, the nonohmic back contact in the bifacial device negatively limits the open circuit voltage and fill factor, evidencing by illumination-/temperature-dependent J–V and frequency-dependent capacitance–voltage (C–V–f) measurements. A 3.4% efficient solar cell is demonstrated under simultaneously bifacial illumination from both sides of TCO front and back contacts.Keywords
Funding Information
- Division of Chemistry (CHE-1230246)
- National Natural Science Foundation of China (61474045)
- Chinese Academy of Sciences (Y2K4401DG0)
This publication has 62 references indexed in Scilit:
- Correlation between intrinsic defects and electrical properties in the high-quality Cu2ZnSnS4 single crystalApplied Physics Letters, 2013
- Co-evaporated Cu2ZnSnSe4 films and devicesSolar Energy Materials and Solar Cells, 2012
- Kesterite Thin‐Film Solar Cells: Advances in Materials Modelling of Cu2ZnSnS4Advanced Energy Materials, 2012
- 6% Efficiency Cu2ZnSnS4-based thin film solar cells using oxide precursors by open atmosphere type CVDJournal of Materials Chemistry, 2012
- A study of energy band gap versus temperature for Cu2ZnSnS4 thin filmsPhysica B: Condensed Matter, 2012
- Discussion of some “trap signatures” observed by admittance spectroscopy in CdTe thin-film solar cellsJournal of Applied Physics, 2010
- Interpretation of admittance, capacitance-voltage, and current-voltage signatures in Cu(In,Ga)Se2 thin film solar cellsJournal of Applied Physics, 2010
- Effect of back-contact barrier on thin-film CdTe solar cellsThin Solid Films, 2006
- Interpretation of capacitance measurements in CuInS2 – on-Cu-tape solar cellsThin Solid Films, 2004
- Solar cell fill factors: General graph and empirical expressionsSolid-State Electronics, 1981