Shear bond strength of acid and laser conditioned enamel and dentine to composite resin restorations: An in vitro study
Open Access
- 18 February 2021
- journal article
- research article
- Published by Wiley in Clinical and Experimental Dental Research
- Vol. 7 (3) , 331-337
Abstract
Objective: To compare the shear bond strength of enamel or dentin conditioned with either Er,Cr:YSGG (erbium, chromium: yttrium–scandium–gallium–garnet) laser or phosphoric acid to composite resin restoration.Material and methods: Forty posterior human extracted teeth were used. After mesiodistal sectioning of the teeth crowns, the samples were randomly divided into two groups—in the first group (E), bonding was performed on the enamel after roughening and in the second group (D), the enamel was removed and bonding was performed on the dentin. These groups were further randomly divided into two subgroups according to the type of etching (n = 20 each). In the acid‐etched groups (EA and DA), the surfaces were etched with 37% phosphoric acid. In the laser‐conditioned groups (EL and DL), the surfaces were conditioned with Er,Cr:YSGG laser. Total‐etch adhesive system was used to bond all the 80 specimens resin composite. The composite was vertically light‐cured, and the specimens were subjected to a shear bond strength test. Modes of bond failure were determined with a stereomicroscope.Results: The highest shear bond strength was observed for the DA group (16.25 ± 1.10 MPa, p < 0.0001), whereas the lowest was observed for the DL group (8.56 ± 0.67 MPa). The adhesive failure mode was the most frequently observed in all groups.Conclusions: The shear bond strength of composite resin bonded to enamel and dentin etched with phosphoric acid was higher than when conditioned with Er,Cr:YSGG laser. Thus, laser conditioning is not recommended.Keywords
This publication has 38 references indexed in Scilit:
- The effect of an Er,Cr:YSGG laser on the micro-shear bond strength of composite to the enamel and dentin of human permanent teethLasers in Medical Science, 2011
- Shear bond strength of bonding to enamel with different laser irradiation distancesLasers in Medical Science, 2010
- Influence of different power outputs of erbium, chromium:yttrium–scandium–gallium–garnet laser and acid etching on shear bond strengths of a dual-cure resin cement to enamelLasers in Medical Science, 2009
- Effect of Er,Cr:YSGG Laser Parameters on Shear Bond Strength and Microstructure of DentinePhotomedicine and Laser Surgery, 2009
- Shear Bond Strength of Composite Bonded to Er,Cr:YSGG Laser-Prepared DentinPhotomedicine and Laser Surgery, 2008
- Er:YAG laser cavity preparation and composite resin bonding with a single‐component adhesive system: Relationship between shear bond strength and microleakageLasers in Surgery and Medicine, 2006
- Erbium:YAG (2.94 μm) Laser Effects on Dental TissuesJournal of Laser Applications, 1990
- Morphology, Histology and Crystallography of Human Dental Enamel Treated with Pulsed Low-Energy Infrared Laser RadiationCaries Research, 1987
- Variation in the Pattern of Acid Etching of Human Dental Enamel Examined by Scanning Electron MicroscopyCaries Research, 1975
- A Simple Method of Increasing the Adhesion of Acrylic Filling Materials to Enamel SurfacesJournal of Dental Research, 1955