Enhanced Transient Heat Transfer From Arrays of Jets Impinging on a Moving Plate
- 15 October 2012
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 34 (4) , 361-371
Abstract
This article addresses the numerical analysis of single and multiple circular jets impinging perpendicularly on a flat plate for heating and cooling purposes. Computational fluid dynamics (CFD) is used to evaluate heat transfer calculations for different configurations and different flow boundary conditions. The commercial CFD package FLUENT is employed with various turbulence models. Results for a single jet are validated against experimental data. The SST k − ω turbulence model is compared with the elliptic V2F model, and both were validated against experimental data. Results were obtained for a range of jet Reynolds numbers and jet-to-target distances. Optimization results for the single jet case are validated against experimental data. The SST k − ω and V2F turbulence models succeeded with a reasonable accuracy (within 20% error) in reproducing experimental results. The heat transfer rates from the use of multijet configurations are discussed in the article. Transient heat transfer between multiple jets and a moving plate is more difficult to study due to the changing boundaries but is also very relevant in engineering applications. This article presents full CFD calculations of the transient heat transfer between a bank of circular jets and a moving plate. Design optimization has also been achieved for the single- and multiple-jet configurations.Keywords
This publication has 20 references indexed in Scilit:
- Heat transfer to a row of impinging jets in consideration of optimizationInternational Journal of Heat and Mass Transfer, 2002
- The effect of nozzle aspect ratio on stagnation region heat transfer characteristics of elliptic impinging jetInternational Journal of Heat and Mass Transfer, 2000
- STAGNATION REGION HEAT TRANSFER OF A TURBULENT AXISYMMETRIC JET IMPINGEMENTExperimental Heat Transfer, 1999
- Numerical study of turbulent heat transfer in confined and unconfined impinging jetsInternational Journal of Heat and Fluid Flow, 1999
- Prediction of heat transfer in an axisymmetric turbulent jet impinging on a flat plateInternational Journal of Heat and Mass Transfer, 1998
- Effect of nozzle geometry on local convective heat transfer to a confined impinging air jetExperimental Thermal and Fluid Science, 1996
- Air jet impingement heat transfer at low nozzle-plate spacingsInternational Journal of Heat and Mass Transfer, 1994
- An Experimental Study of Entrainment Effects on the Heat Transfer From a Flat Surface to a Heated Circular Impinging JetJournal of Heat Transfer, 1991
- Heat Transfer Measurements From a Surface With Uniform Heat Flux and an Impinging JetJournal of Heat Transfer, 1989
- Development of Theoretical Models for Jet-Induced Effects on V/STOL AircraftJournal of Aircraft, 1976