Comparison between Micro-Computed Tomography and Cone-Beam Computed Tomography in the Assessment of Bone Quality and a Long-Term Volumetric Study of the Augmented Sinus Grafted with an Albumin Impregnated Allograft
Authors:
Open Access
- 21 January 2020
- journal article
- research article
- Published by MDPI AG in Journal of Clinical Medicine
- Vol. 9 (2) , 303
Abstract
The purpose of our study was to compare micromorphometric data obtained by cone-beam computed-tomography (CBCT) and microcomputed-tomography (micro-CT) of the augmented sinus and to evaluate the long-term stability of the bone gain achieved using BoneAlbumin. Sinus lifts, and after 6-months, healing bone-biopsy and implant placement were carried out. Specimens were analyzed by micro-CT. A total of 16 samples were collected from nine patients (mean age 54.7 ± 6.5 years). Pre-, postoperative, and 3-year control CBCT-data were registered to determine from where the biopsy samples were harvested. Micromorphometric variables were calculated from the micro-CT- and CBCT-data, and their correlation was determined by Spearman’s test. The volume of augmented bone was calculated at the time of implant placement and after 3 years. A positive correlation was found between bone-volume fraction, trabecular-separation, open-, and total-porosity, while a negative correlation was found between trabecular-thickness obtained from CBCT- and micro-CT-data (p < 0.05). Mean volumetric reduction of 39.28% (11.88–60.02%) was observed. Correlation of CBCT- and micro-CT-data suggested that micromorphometric analysis of CBCT reconstructions of the augmented sinuses provided reliable information on the microarchitecture of augmented bone. CBCT as a modality might be adequate in the analysis of bone quality in the augmented sinus. At the 3-year, control sinus grafts showed volumetric stability.Keywords
Funding Information
- Semmelweis University Faculty of Dentistry Research Grant (2017/9)
This publication has 49 references indexed in Scilit:
- Is micro‐computed tomography reliable to determine the microstructure of the maxillary alveolar bone?Clinical Oral Implants Research, 2012
- Artefacts in CBCT: a reviewDentomaxillofacial Radiology, 2011
- Relationship between cortical bone thickness or computerized tomography‐derived bone density values and implant stabilityClinical Oral Implants Research, 2010
- Bone quality assessment based on cone beam computed tomography imagingClinical Oral Implants Research, 2009
- A histomorphometric meta-analysis of sinus elevation with various grafting materialsHead & Face Medicine, 2009
- Comparison Insight Bone Measurements by Histomorphometry and μCTJournal of Bone and Mineral Research, 2005
- A clinical long‐term radiographic evaluation of graft height changes after maxillary sinus floor augmentation with a 2 : 1 autogenous bone/xenograft mixture and simultaneous placement of dental implantsClinical Oral Implants Research, 2004
- The connEulor: Unbiased estimation of connectivity using physical disectors under projectionBone, 1993
- The direct examination of three-dimensional bone architecture in vitro by computed tomographyJournal of Bone and Mineral Research, 1989
- A study of the dimensional changes occurring in the maxilla following tooth extraction*Australian Dental Journal, 1969