Friction Stir Welding of AZ31 Magnesium Alloys - A Numerical and Experimental Study
Open Access
- 1 January 2017
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 14 (1) , 113-130
Abstract
In this paper, weldability of magnesium alloys by friction stir welding (FSW) method which is difficult to join by the fusion welding have been investigated experimentally and numerically. To this end, the connection of magnesium alloys was performed using different welding parameters. AZ31 Mg-alloy plates were friction stir welded at rotation speed of 1200 rev/min and translational speeds of 80,100,120,140 mm/min. Temperature evolution in the weld zone during welding was measured by using embedded K-type thermocouples. The temperature measurements on both advancing and retreading sides were performed by ten thermocouples. Tensile and Vickers hardness tests were conducted to evaluate the mechanical properties and the hardness distribution on the weld, respectively. During FSW, heat is generated by the friction and plastic deformation. Knowledge of the temperature distribution is requisite since mechanical properties and microstructure are substantially affected by the heat generation. It was observed that the heat generated during the FSW process was increasing and the grain structure was refined as the translational speed was decreasing. In the finite element analyses, modeling of the FSW process were carried out by ANSYS software to determine the temperature and stress distributions in the welded joint during FSW. An APDL (ANSYS Parametric Design Language) code was developed to simulate FSW process. Transient nonlinear finite element analyses were performed at two stages which the first step is thermal analysis which heat transfer from the pin and shoulder to the plates was modeled and the second is the structural analysis which the temperature data obtained from the thermal analysis in the first stage is used.Keywords
This publication has 17 references indexed in Scilit:
- Thermo-mechanical and metallurgical aspects in friction stir processing of AZ31 Mg alloy—A numerical and experimental investigationJournal of Materials Processing Technology, 2013
- Effect of Friction Stir Processing on Microstructure and Mechanical Properties of Cast AZ31 Magnesium AlloyRare Metal Materials and Engineering, 2012
- Grain structure evolution during friction-stir welding of AZ31 magnesium alloyActa Materialia, 2009
- Effect of welding speed on the quality of friction stir welded butt joints of a magnesium alloyMaterials & Design (1980-2015), 2009
- Friction stir welding of AZ31 magnesium alloy rolled sheets: Influence of processing parametersActa Materialia, 2009
- Friction stir processing of commercial AZ31 magnesium alloyJournal of Materials Processing Technology, 2007
- The influence of the ratio of “rotational speed/traverse speed” (ω/v) on mechanical properties of AZ31 friction stir weldsInternational Journal of Machine Tools and Manufacture, 2006
- Thermo-mechanical model with adaptive boundary conditions for friction stir welding of Al 6061International Journal of Machine Tools and Manufacture, 2005
- Relationship between grain size and Zener–Holloman parameter during friction stir processing in AZ31 Mg alloysScripta Materialia, 2004
- An analytical model for the heat generation in friction stir weldingModelling and Simulation in Materials Science and Engineering, 2003