Microstructures, mechanical and tribological properties of VN films deposited by PLD technique
- 22 March 2016
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (40) , 33403-33408
Abstract
Consistent stoichiometric FCC structured vanadium nitride (VN) films were fabricated by the pulsed laser deposition (PLD) technique at room temperature and 300 °C, for which the microstructures and mechanical and tribological properties were systematically investigated. The results indicated that the films deposited at 300 °C displayed a denser structure and possessed higher hardness and elastic modulus values than the films deposited at room temperature that exhibited a columnar structure. The wear behaviors of VN films were investigated at elevated temperature to 900 °C against an alumina ball under an ambient atmosphere. Due to the densified structure and excellent mechanical properties, the VN films deposited at 300 °C held lower friction coefficients over the investigated temperature range compared to those of the films deposited at room temperature and registered the lowest friction coefficient of about 0.21 at 900 °C. According to the XRD and Raman spectroscopy results, the oxidation behaviors of VN films at elevated temperatures formed a series of vanadium oxides, such as V2O5, V3O7, V6O11 and V6O13, which displayed easy crystallographic shear planes with reduced binding strength and influenced the tribological properties significantly. Moreover, liquid self-lubrication existed in the tribology process above 700 °C due to the melting of V2O5 that registered low melting points of 680 °C. Combining the vanadium oxides phase and lubrication phases with the lubricious oxide layer, as well as the liquid lubrication in the contact area, can cause decreased friction coefficients at higher temperatures.Keywords
This publication has 38 references indexed in Scilit:
- Mechanical and electrochemical characterization of vanadium nitride (VN) thin filmsApplied Surface Science, 2011
- Adaptive VN/Ag nanocomposite coatings with lubricious behavior from 25 to 1000°CActa Materialia, 2010
- Progress in the development of adaptive nitride-based coatings for high temperature tribological applicationsSurface and Coatings Technology, 2009
- Structural characterizations of magnetron sputtered nanocrystalline TiN thin filmsMaterials Characterization, 2008
- Mechanical properties of nanocrystalline materialsProgress in Materials Science, 2006
- Influence of oxide phase formation on the tribological behaviour of Ti–Al–V–N coatingsSurface and Coatings Technology, 2005
- Raman microscopic studies of residual and applied stress in PVD hard ceramic coatings and correlation with X-ray diffraction (XRD) measurementsSurface and Coatings Technology, 2004
- Structure–property relationships in single- and dual-phase nanocrystalline hard coatingsSurface and Coatings Technology, 2003
- Deformation behavior of titanium nitride film prepared by plasma immersion ion implantation and depositionSurface and Coatings Technology, 2002
- Tribological properties, phase generation and high temperature phase stability of tungsten- and vanadium-oxides deposited by reactive MSIP-PVD process for innovative lubrication applicationsSurface and Coatings Technology, 2000