Prediction of Part Shrinkage for Injection Molded Crystalline Polymer via Cavity Pressure and Melt Temperature Monitoring
Open Access
- 31 August 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (17) , 9884
Abstract
During an injection molding process, different parts of the molded material are subjected to various thermal–mechanical stresses, such as variable pressures, temperatures, and shear stresses. These variations form different pressure–temperature paths on the pressure–volume–temperature diagram. If these paths cannot converge at a specific target volume value during ejection, it often leads to different levels of shrinkage and associated warping, which pose a significant challenge for molders during mold trials and part quality control. The situation is particularly complicated when molding crystalline polymers because the degree of crystallinity depends on the processing conditions and may vary across different locations. In this study, we propose an innovative and practical approach to improving part shrinkage when molding crystalline polymers. For the first time, we utilized melt temperature profile monitoring rather than the previous mold temperature measurement to detect the crystallization process and determine the time taken to complete the crystallization at different melt and mold temperatures. In addition, we used response surface methodology to build a crystallization time prediction model. The feasibility of the prediction model was verified by determining the warpage of parts molded at various cooling times. Based on this model, we varied the packing pressure, packing time, and melt temperatures to determine the correlation with part shrinkage. Through regression analysis, the time-averaged solidification pressure values can accurately control part shrinkage. Two prediction models provide reasonable accuracy and efficiency for part shrinkage control, as demonstrated by subsequent verification experiments.Keywords
Funding Information
- National Science and Technology Council (111-2622-8-033-002)
- Smart Manufacturing R&D Centers for Semiconductor Carrier of Chung Yuan Christian University, Taiwan, ROC (111-2622-8-033-002)
This publication has 25 references indexed in Scilit:
- On the relationship between cooling setup and warpage in injection moldingMeasurement, 2012
- Pressure influence on crystallization kinetics during injection moldingJournal of Materials Processing Technology, 2011
- A comparison of seven filling to packing switchover methods for injection moldingPolymer Engineering & Science, 2010
- On-line testing equipment of P–V–T properties of polymers based on an injection molding machinePolymer Testing, 2009
- Simulation of phase‐change heat transfer during cooling stage of gas‐assisted injection molding of high‐density polyethylene via enthalpy transformation approachPolymer Engineering & Science, 2009
- Numerical prediction of phase‐change heat conduction of injection‐molded high density polyethylene thick‐walled parts via the enthalpy transforming model with mushy zonePolymer Engineering & Science, 2008
- Modeling of morphology evolution in the injection molding process of thermoplastic polymersProgress in Polymer Science, 2005
- A review of current developments in process and quality control for injection moldingAdvances in Polymer Technology, 2005
- P-V-T relations in a series of longitudinal polymer liquid crystals with varying mesogen concentrationPolymer, 1998
- Infrared temperature measurement of polymersPolymer Engineering & Science, 1996